User Guide for KLARK TECKNIK models including: CP8000UL, Remote Control for Volume and Source Selection
and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. KLARK TEKNIK
Introduction. Welcome! Thank you for purchasing the CP8000UL remote control panel for the DM8000 Digital Audio Processor. In conjunction with.
File Info : application/pdf, 7 Pages, 920.93KB
DocumentDocumentCP8000UL Remote Control for Volume and Source Selection Quick Start Guide 2 CP8000UL 1. Introduction Welcome! Thank you for purchasing the CP8000UL remote control panel for the DM8000 Digital Audio Processor. In conjunction with DM8000, the CP8000UL panel provides easy control over volume and source selection. All illuminated soft-touch controls are remotely powered by DM8000 via CAT5/6 cabling, or any 5-conductor cable. The CP8000UL will fit in most standard-depth installation enclosures and will blend with any décor. 2. Front Panel (1) Quick Start Guide 3 (2) (3) CP8000UL Front Panel 1. AUXILIARY INPUT LABELING area provides space to note the name of the assigned audio source. You may write directly on the surface or apply sticky labels. 2. SOFT TOUCH BUTTONS can each be assigned to a separate audio input. Press the button to activate the audio input assigned to that button. When a button is active, the embedded LED lights up. 3. VOLUME KNOB controls the output level. The volume control can be assigned to the auxiliary input section or main input bus. 4 CP8000UL 3. Assembly and Mounting The CP8000UL fastens into the installation enclosure with two screws beneath the front plate. Remove the front panel, and fasten the main unit into the enclosure with the provided mounting screws. When the unit is securely fastened, replace the front panel. 4. Dimensions 70 [2.8] Quick Start Guide 5 114 [4.5] 37 [1.5] 6 CP8000UL 5. Specifications Power Supply Input selection Volume Connector Cable Cable length Dimensions / Weight Dimensions (H x W x D) Weight 6 x soft touch buttons 1 x rotary control 5-pin euroblock Cat5/6 Up to 100 m (300 ft) 114 x 70 x 37 mm (4.5 x 2.8 x 1.5") 0.08 kg (0.176 lbs) Quick Start Guide 7 LEGAL DISCLAIMER MUSIC Group accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. MIDAS, KLARK TEKNIK, LAB GRUPPEN, LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON, BEHRINGER, BUGERA and DDA are trademarks or registered trademarks of MUSIC Group IP Ltd. © MUSIC Group IP Ltd. 2017 All rights reserved. LIMITED WARRANTY For the applicable warranty terms and conditions and additional information regarding MUSIC Group's Limited Warranty, please see complete details online at music-group.com/warranty. 8 CP8000UL FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION KLARK TEKNIK Responsible Party Name: Address: Phone No.: Music Group Research UK Limited Klark Industrial Park, Walter Nash Road, Kidderminster. Worcestershire. DY11 7HJ. England. +44 1562 741515 CP8000UL This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Quick Start Guide 9 This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This product conforms with essential requirements of the EMC Directive 2014/30/EU, the LV Directive 2014/35/EU, RoHS Directive 2011/65/EU and WEEE Directive - 2012/19/EU. Warning: Operation of this equipment in a residential environment could cause radio interference. 10 CP8000UL Quick Start Guide 11