MOMAN Microphone M1 Wireless System User Manual

Caring For Your MOMAN Product

• Please keep the product in a dry, clean, dust-free environment.
• Keep corrosive chemicals, liquids and heat source away from the product to prevent mechanics damage.
• Use only a soft and dry cloth for cleaning the product.
• Malfunction may be caused by dropping, impact of external force.
• Do not attempt to disassemble the product. Doing so voids warranty.
• Please have the product checked or repaired by authorized technicians if any malfunctions happened.
• Failure to follow all the instructions may result in mechanics damage.
• Warranty does not apply to human errors.

Packing List

Product Introduction

1. TX Transmitter

(Depiction: A rectangular device with a clip on the back. On the front, from top to bottom, are a power key, a working indicator light, and a built-in microphone. A Type-C charging port is on the side.)

1. Power Key
2. Working Indicator
3. Built-in Microphone
4. Back Clip
5. Type-C Charging Port

2. RX Receiver

(Depiction: A rectangular device with a connector plug (Type-C or Lightning) at one end. On the body, there is a volume button, a Type-C port, a working indicator light, and the main connector.)

1. Volume Button
2. Type-C Port
3. Working Indicator
4. Connector

3. Indicator

* Note: The indicator identification shown as follows.

Left ⬅️ M1 ➡️ Right

Receiver Working Indicators (White Light)

Transmitter Working Indicators (White Light)

Operations

1. Turn On/Off

1. Transmitter: Long press the power button of the transmitter for 3 seconds.

   *Note: The transmitter will shut down automatically if it is unpaired or disconnected for 5 minutes.

2. Receiver: Insert the mobile phone device to switch on automatically, and the indicator flashes.

(Depiction: A diagram showing the receiver plugged into a mobile phone.)

2. Charge

Transmitter:

Charge the transmitter via the Type-C charging port and charging cable.

(Depiction: A diagram showing the transmitter connected to a charging cable.)

Mobile Phone:

Insert your phone's charging cable into the Type-C port of the receiver when in use, and the charging current is adjusted according to the phone's battery max up to 800mA.

*Note: The receiver does not need to be charged and can be used directly when plugged in the phone.

(Depiction: A diagram showing the receiver connected to a mobile phone, with a charging cable also connected to the receiver.)

3. Pairing

The transmitter and receiver will automatically start pairing once power on.

*Note: For M1L/M1T, each transmitter can only pair with a receiver.

4. Adjust the Volume

Press the receiver volume button to adjust the volume and the number of indicators shows the current volume level.

Double press the volume button to enable or disable mute and single indicator keeps on when mute is on.

(Depiction: A diagram showing the receiver with five indicator lights representing volume levels (Lv.1 to Lv.5) and a separate indicator for Mute.)

• ⚪⚪⚪⚪⚪ Lv.1
• ●⚪⚪⚪⚪ Lv.2
• ●●⚪⚪⚪ Lv.3
• ●●●⚪⚪ Lv.4
• ●●●●⚪ Lv.5
• * Mute

5. Noise Reduction

Press the power button of the transmitter to turn on the noise reduction, the single indicator keeps on.

* Double press the power button of the transmitter to turn off/on the light effect.

(Depiction: A diagram showing a hand pressing the power button on the transmitter.)

Specifications

TX Transmitter

RX Receiver