HEADRUSH™ BURST BOOMBOX WITH FM RADIO

HRSP 5022

Instruction Manual

WHAT'S INCLUDED:

COMPONENT IDENTIFICATION:

Side A

1. Mode Button

2. Bluetooth®

3. Power bank

4. EQ

5. Power ON/OFF

6. Battery LED

7. Previous track/Decrease volume

8. Play/Pause/Mute (Multi-function button-MFB)

9. Next track/Increase volume

10. Micro USB charging port

11. 3.5mm AUX in

12. DC out

Side B

PRODUCT OVERVIEW

You can use this item with any compatible, Bluetooth®-enabled device to stream music and enjoy hands-free calling. Please read this manual first before using.

FEATURES:

  1. Bluetooth® 4.2
  2. MAXX AUDIO DSP by Waves
  3. Hands-free telephone calling
  4. Operating distance up to 10m (30ft.)
  5. Operation time up to 10 hours (half volume level)
  6. AUX-in 3.5mm/microSD
  7. FM Radio
  8. Built-in EQ modes and power bank
  9. Electronic beep prompt
  10. IPX4

OPERATING INSTRUCTIONS

TODO THIS
Power ONPress and hold the ⏻ button for 2 seconds.
Power OFFPress and hold the ⏻ button for 2 seconds.
Play/PausePress the MFB once to pause. Press again to resume.
Increase volumePress and hold the + button.
Next trackPress the + button.
Next FM channelPress the + button while in FM mode.
Switch from speaker to deviceDuring a call, press the + or - button to switch from speakerphone to your device.
Decrease volumePress and hold the - button.
Previous trackPress the - button.
Previous FM channelPress the - button while in FM mode.
Answer/end a callPress the ⏻ button.
Disconnect Bluetooth®/reject a callPress and hold the ⏻ button.
Adjust EQ modesPress the EQ button to switch between Normal, Bass and Treble modes.
Auto-search FM stationsPress and hold the MFB for 3 seconds.
Reset defaultPress and hold the MFB for 8 seconds.
Select input modePress the M button to switch between Bluetooth®, FM and AUX-in modes.

CHARGING

Use the included charging cable to fully charge the speaker before first use. It will take approximately 5 hours to fully charge. Excessive or prolonged charging can damage the battery's lifetime.

NOTE: Please charge the speaker immediately if the battery is low. If you don't use the speaker regularly, charge it at least once a month in order to prevent the Lithium battery from deteriorating. Using an adapter rated lower than 5V/2A will result in a slower charging speed. As a power-saving function, the speaker will power OFF after 10 minutes of being paused or attempting to pair.

POWER BANK

The speaker has a built-in 4400 mAh battery power bank. To charge your other devices with the power bank, please follow these steps.

  1. Power OFF the speaker and connect your device to the speaker's USB charging port.
  2. Press the ⏻ button on the speaker to begin charging the connected device.

NOTE: The speaker charges devices with a voltage at 5V, and an output current at 2.1A.

PAIRING

Ensure your Bluetooth® device is within 10m (30ft.) of the speaker.

  1. Press and hold the power ON/OFF button to turn the speaker ON. Enter Bluetooth® mode by pressing "M". There will be one beep. The LED will flash blue ??. (Alternatively, you can press the ⏻ button to enter into pairing mode.)
  2. Turn the Bluetooth® ON in your device settings and select "HR BURST", enter password "0000" if required.
  3. Once paired successfully, the speaker will beep and the LED will stop flashing blue.

NOTE: The next time you turn the speaker ON, it will connect automatically as long as the Bluetooth® function on your device is switched ON and is within range. If you haven't disconnected and cleared the Bluetooth® connection, press and hold the ⏻ button to disconnect and clear the Bluetooth® connection. The device will disconnect and the speaker will beep once.

HANDS-FREE SPEAKERPHONE

When a smartphone is connected to your speaker, follow the steps below to take calls hands-free.

  1. If there is an incoming call while streaming music, the music will pause and your ring tone will play.
  2. Press the ⏻ button to pick up the call.
  3. Press and hold ⏻ button to reject the call.
  4. Press - or + to switch between speaker and smartphone.
  5. Press the ⏻ button again to hang up the call.
  6. Press the ⏻ button twice to redial.

UNDERSTANDING THE LED STATUS LIGHTS

AUX IN

  1. Use the supplied 3.5mm audio cable to connect the speaker directly with your device.
  2. Once connected, press the M button to enter the AUX-in mode, the speaker will beep twice. Music from the connected device will play.
  3. When the 3.5mm audio cable is unplugged, the speaker will return to the previous Bluetooth® connection.

NOTE: A 5V, 2A adaptor is recommended to charge the speaker while it is connected to a PC via AUX in. If you press the MFB while the speaker is in AUX-in mode, it will mute the music but the song will continue on your device.

FM RADIO

  1. Press the M button to switch into FM mode. The speaker will beep three times.
  2. Press and hold the MFB button to begin an automatic search for channels.
  3. Press the +/- buttons to switch to next and previous channels.

TECHNICAL SPECIFICATIONS

NOTE: This speaker is in compliance with the specified Bluetooth® version. It does not guarantee compatibility with all the functions on every Bluetooth®-enabled device. Please check your smartphone's user manual for compatibility and functionality.

TROUBLESHOOTING

Cannot power ON:

No Sound:

Distorted sound:

Cannot connect with Bluetooth® device:

WARNINGS

INDUSTRY CANADA NOTICE RSS 247

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of Industry Canada.

IC: 255A-8080303

WARNING

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority for recycling advice. ♻️

THE SOURCE - WARRANTY

The Source warrants that this product will be free from defects in materials and workmanship for a period of 12 months from the date of purchase. Within this period, simply take the product and your proof of purchase to any The Source store or participating dealer and the product will be replaced (where available) without charge. Any product which has been subject to misuse or accidental damage is excluded from this warranty.

This warranty is only applicable to a product purchased through The Source company-owned stores or participating dealers in Canada where the warranty is included with the product. While this warranty does not confer any legal rights other than those set out above, you may have additional statutory rights which will vary under the laws of the various countries, states, provinces and other governmental entities in which The Source operates. This warranty is subject to all statutory rights you may have in Canada.

Imported by: The Source, Barrie, Ontario, Canada, L4M 4W5

Manufactured in China

www.thesource.ca

©2019 The Source. All rights reserved.

PDF preview unavailable. Download the PDF instead.

108080303 Manual Adobe PDF Library 9.0 Adobe InDesign CS4 (6.0)

Related Documents

PreviewHeadrush HRSP 5042 Wireless Speaker User Manual
User manual for the Headrush HRSP 5042 wireless speaker, covering Bluetooth pairing, TWS connection, hands-free calling, operation, charging, and troubleshooting.
PreviewHeadrush Portable Bluetooth Speaker User Guide
This user guide provides instructions for the Headrush Portable Bluetooth Speaker (model 8004081/82), covering setup, pairing, charging, operation, and safety information. Learn how to connect wirelessly to Bluetooth-enabled devices, manage calls, and troubleshoot common issues.
PreviewHeadRush VIBE Wireless Speaker Instruction Manual
Instruction manual for the HeadRush VIBE Wireless Speaker (Model HRSP 5040), covering product overview, operation, TWS connection, charging, pairing, hands-free speakerphone, line-in mode, technical specifications, and troubleshooting.
PreviewHeadrush Urban - Mini Portable Bluetooth Speaker with NFC - Model 8062738
Explore the Headrush Urban - Mini, a compact portable Bluetooth speaker featuring NFC technology, 5W RMS output, and a 1300mAh battery. Includes technical specifications, dimensions, and control button descriptions.
PreviewHeadRush HRB 3038 True Wireless Earbuds: User Manual and Specifications
Comprehensive guide for HeadRush HRB 3038 True Wireless Earbuds, covering setup, operation, charging, pairing, troubleshooting, safety, and specifications. Learn how to use your earbuds effectively.
PreviewHeadRush HRF 801 2.4GHz Wireless Headphones Instruction Manual
User guide for the HeadRush HRF 801 wireless headphones, covering setup, operation, troubleshooting, specifications, and care instructions.
PreviewHeadRush HRF 5020 Noise-Cancelling Wireless Over-Ear Headphones - User Manual
Comprehensive user manual for the HeadRush HRF 5020 noise-cancelling wireless over-ear headphones, covering setup, operation, features, and specifications.
PreviewHEADRUSH HRSP3037 WAVE II Wireless Waterproof Floating Bluetooth Speaker - Instruction Manual
Instruction manual for the HEADRUSH HRSP3037 WAVE II, a wireless, waterproof, floating Bluetooth speaker. Learn about its features, operation, pairing, TWS connection, technical specifications, and troubleshooting.