GIMA Classic Aluminium Wheelchair - 46 CM

Introduction

Thank you for purchasing a GIMA product. The wheelchairs are designed and manufactured to meet all your needs for practical, correct, and safe use. This manual contains suggestions for correct use of the device and valuable advice for your safety. It is recommended to read the entire manual carefully before using the item. In case of doubt, contact your retailer for the most accurate guidance.

Note: Check all parts to ensure there are no damages caused by shipping. If damages are found, do not use the wheelchair. Contact the retailer for further instructions.

Declaration of Conformity

INTCO MEDICAL declares under its sole responsibility that the products belonging to the wheelchair category comply with the European Medical Device Directive (93/42/EEC). INTCO MEDICAL guarantees and declares under its sole responsibility the following:

• The devices in question meet the essential requirements of Annex I of Directive 93/42/EEC as provided by Annex VII of the aforementioned Directive.
• The devices in question belong to Class I.
• The use of these devices outside their intended purpose is NOT PERMITTED.
• The items also comply with all applicable European standards.

Reportable Incidents: Any serious incident that occurred in relation to the medical device supplied must be reported to the manufacturer and the competent authority of the member state where your registered office is located.

CE Mark: Conforms to EU regulations (Regulation (EU) 2017/745)

MD: Medical Device

Usage

Wheelchairs are an essential means of transport for people with disabilities, with reduced or no motor skills. The purpose is to facilitate independent movement and safeguard the person's physical well-being, preventing complications related to the seated position (pressure sores, chronic postural pain...).

Warnings

• Consult your doctor or therapist to determine the correct adjustment and use.
• Always pay attention to moving parts that could cause entrapment and injury to limbs.
• Pay particular attention to wet surfaces.
• It is recommended to be aware of the risk of finger entrapment in some parts, such as wheels or brakes, when using the wheelchair.

Description

• Aluminum frame with double crossbar.
• Smoky grey powder-coated frame.
• Rear wheels with quick-release*.
• Small wheels for lifting.
• Rear wheels: 60 cm (24") with PU tires.
• Front wheels: 20 cm (8") with PU tires.
• Padded polyester seat and backrest.
• Flip-up armrests with desk length.
• Swinging, detachable, and height-adjustable footrests.

Technical Specifications

Assembly

Frame Opening and Closing

To open the frame: Grasp the armrests and pull them outwards.

To close the wheelchair: Lift the seat and push the seat downwards, bringing the two armrests closer together.

Adjustable Footrests

To install the footrests: Align the support holes with the corresponding pins on the wheelchair frame, then rotate the footrest inwards, correctly engaging the locking lever to the wheelchair frame. To remove them: Disengage the footrest lever from the wheelchair frame, then rotate them outwards and pull upwards.

Managing Rear Wheels

To manage the rear wheels: Press the button located in the center of the wheels and slide them off. To reinsert the wheels: Press the central button and insert the pin into the frame hole.

Usage

Getting on the Wheelchair

• Bring the wheelchair close to the patient.
• Lock the rear wheel brakes. It is recommended to remove the armrest laterally. Lean on the frame, using your arms for support, then slowly lower yourself towards the seat.

Getting off the Wheelchair

• Move as close as possible to a new place to sit.
• Lock the rear wheel brakes. Remove the armrest on the side. Place your arms on the frame of the seat you are moving to, then slowly lift yourself towards it.

IMPORTANT! Assistance or supervision from qualified personnel is required to prevent slips and falls.

Movement

Grasp the rear wheel handrims and push in the desired direction. If necessary, healthcare personnel or the operator can push the wheelchair using the knobs located on the backrest.

Cleaning

Use a damp cloth with neutral soap. The water temperature should not exceed 30°C. Dry thoroughly before use. If necessary, disinfect the product using a common disinfectant detergent. Do not use water jet or steam cleaning devices. Do not use acidic, alkaline, or solvent products such as acetone.

General Disposal Conditions and Product Information

For the disposal of the device, never use housings for solid waste collection systems. The device must be disposed of through common ecological collection points for recycling used materials.

Storage: Keep in a cool and dry place.

Storage: Protect from sunlight.

Read instructions for use.

Date of manufacture: [Not specified in document]

Atmospheric pressure limit: [Not specified in document]

Humidity limit: [Not specified in document]

Temperature limit: [Range: -40°C to 65°C]

GIMA Warranty Conditions

The standard GIMA B2B warranty of 12 months applies.

Disposal: The product must not be disposed of with other domestic waste. Users must arrange for the disposal of equipment to be scrapped by taking it to the designated collection point for the recycling of electrical and electronic equipment.