User Manual for Infinix models including: X6881, X6881 HOT 50 Pro Smart Phone, HOT 50 Pro Smart Phone, Smart Phone
INFINIX MOBILITY LIMITED YYS-X6881 2AIZN-YYS-X6881 2AIZNYYSX6881 yys x6881
File Info : application/pdf, 10 Pages, 248.82KB
DocumentDocumentInfinix HOT 50 Pro X6881 User Manual(E&J) Exploded diagram specification 1 TP+LCM 2 FRONT COVER 3 MB CU FOIL A 4 RECEIVER 5 FRONT CAMERA 6 REAR CAMERA BTB FOAM 7 SIM CARD 8 MAIN BOARD 9 2W REAR CAMERA ADHESIVE 10 MB CU FOIL B 11 2W REAR CAMERA 12 50M REAR CAMERA 13 SIDE KEY FPC 14 2M REAR CAMERA RUBBER 15 FLASH FPC 16 LIGHT FPC 17 FRONT CAMERA CU FOIL 18 PS RUBBER 19 MAIN BOARD GRAPHITE 20 MIDDLE COVER 21 SCREW M1.4*L3.5 22 BATTERY COVER 23 DECO FRAME 24 DECO PLATE 25 GLASS LENS MAIN 26 GLASS LENS AUX 27 COMPOSITE LENS 28 SCREW M1.4*L2.5 29 AUDIO JACK RUBBER 30 USB RUBBER 31 MOTOR 32 SMALL BOARD 33 SPEAKER 34 FINGER FOAM 35 FINGER MODULE 36 COAXIAL CABLE 37 BATTERY 38 MAIN FPC 39 REAR CAMERA CU FOIL 1 Know your phone 2 1. Front camera 2. Volume + button 3. Volume - button 4. Power button 5. NFC SIM/SD card installation 1. Power off your phone. 3 2. Refer to the following picture for SIM/SD card installation. Charging the phone You can charge your phone with a charger or by connecting it to a computer using a USB cable (comes 2 with the phone). Use only Infinix chargers and cables. Other chargers or cables may damage the phone and invalidate its warranty. FCC Caution 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party 3 responsible for compliance could void the user's authority to operate the equipment. Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information: This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: X6881 (FCC ID: 2AIZN-YYS-X6881) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 0.993 W/kg and when properly worn on the body is 0.854W/kg. Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0cm must be maintained between the user's body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any 4 metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights 5 Reserved. Operating System: AndroidTM Android is a trademark of Google LLC. 6