Pioneer VREC-H320SC Dash Camera Quick Start Guide

Introduction

This guide is intended to explain the basic functions of this unit. For details, please refer to the region-wise website.

For more information, visit:

• Pioneer Gulf: https://pioneer-mea.com/en/pioneer-operation-manual/
• Pioneer Electronics AsiaCentre Pte. Ltd.: https://pioneercarentertainment.com/pioneer-operation-manual/

After-Sales Service for Pioneer Products

Please contact the authorized Pioneer dealer from which you purchased this unit or an authorized Pioneer service company for after-sales service or questions you may have about the product. You may contact Pioneer directly as follows:

Pioneer Gulf

Pioneer Gulf Free Zone, P.O. Box 61226, Jebel Ali, Dubai, U. A. E.
Tel: +971 4 8815756 | Fax: +971 4 8816414
E-mail: support@pioneer-mea.com

Pioneer Electronics AsiaCentre Pte. Ltd.

2 Jalan Kilang Barat, #04-02, Singapore 159346
Tel: (65) 6378 7777 / (65) 6378 7888
E-mail: enquiry@pioneer.com.sg

Precautions

Information for users on collection and disposal of old equipment and used batteries

The symbols on the products, packaging, and/or accompanying documents indicate that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery, and recycling of old products, please take them to applicable collection points in accordance with national legislation. By disposing of these products correctly, you will help to save valuable resources and prevent potential negative effects on human health and the environment. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service, or the point of sale where you purchased the items.

When disposing of products, please comply with governmental regulations or environmental public institution's rules that apply in your country/area.

Safety Precautions

Certain country, state, and provincial laws may prohibit or restrict the placement and use of this product in your vehicle. Please comply with all applicable laws and regulations regarding the use, installation, and operation of this product. It is the user's responsibility to comply with all applicable laws, rules, regulations, and ordinances.

❗ Warning

• Do not install this product in your vehicle if its location or use would obstruct the driver's clear view of the road or the operation of any airbag in the vehicle. It is also the owner's/driver's responsibility to know and comply with the laws, rules, and regulations of the driving location, including passenger privacy rights. Do not use the device in any location where its installation or use is prohibited.
• Do not use this device to make audio or video recordings prohibited in the location where you are using this product. Always provide notice that video and audio recordings are being made and obtain appropriate consent and authorization from the persons being recorded. Some states, provinces, and municipalities require posting a visible written notice that occupants and conversations are being recorded.

⚠️ CAUTION

The graphical symbol [DC symbol] placed on the product means direct current.

Product Appearance

Packaging Contents

• 1N Dash Camera [VREC-H320SC or VREC-H320SC-D]
• 1N Power Adapter
• 1N Power Cable
• 1N Electrostatic Film
• 1N Mount With Double-Sided Adhesive
• 1N Quick Start Guide

Device Overview

The product consists of the following parts:

1. Rear camera connection terminal (to connect rear camera cable)
2. Adhesive Mount Cradle connection point
3. Power port (to connect power cable)
4. ON/OFF Power Button
5. System Indicator
6. Speaker
7. Camera Lens
8. LCD Display
9. microSD™ Card Slot
10. Function Touch Button(s)
11. Reset

Specifications

• Resolution: 1080p; Full HD
• Display Screen: LCD; 3 inches; 7.62 cm
• Wi-Fi: In-build (2.4 GHz)
• G-sensor: Supported
• Storage: microSD Card (Class 10 or above; up to 512 GB)
• Power Supply: 5 V, 1.5 A (via cigarette charger slot of vehicle or via Hardwire Kit)
• Power Connector: USB Type-C®
• Power Back-up: Super Capacitor

Status Display

The status display shows the operating status of this product.

Indicator Key:

1. Recording in progress
2. Elapsed recording time
3. Event recording status
4. Parking mode
5. Sound recording*1
6. Wi-Fi connection status*2
7. GPS reception status*3
8. Date/Time/Vehicle speed

*1 A red "\" is displayed when sound recording is set to OFF.
*2 During a Wi-Fi connection, this is displayed in green, and when Wi-Fi is disconnected, this is displayed in white. A red "x" is displayed when Wi-Fi connection is set to OFF.
*3 During GPS reception, this is displayed in green, and when GPS cannot be received, this is displayed in white.

System Indicator Display

The operating status of this product is displayed with the system indicator.

Function Touch Button(s)

The functions of the function touch button(s) are indicated by the icons displayed at the bottom of the screen. The functions of the buttons will depend on the displayed screen. (Icons are not displayed on some screens.) In the playback screen or MENU screen, pressing the [Function Button] function touch button returns you to the previous screen.

Recording Buttons

• 1: Main menu display
• 2: Manual recording of events (Event Recording)
• 3: Take photo
• 4: Playback recorded media
• Switching of camera video*

* Switching between the Dash Camera main unit image and the 2nd camera (sold separately) image is only possible if the 2nd camera (sold separately) is connected.

Using the microSD Card

Inserting and Ejecting the microSD Card

Turn OFF the power to this product when inserting and removing the microSD card.

Inserting the microSD Card

Hold the top edge of the microSD card, position the microSD card so that the microSD card label is facing opposite side of the lens and slowly insert it into the microSD card slot until it clicks.

Ejecting the microSD Card

Slowly push in the top edge of the microSD card until it clicks (1). The lock will be released. Pull out the microSD card (2).

⚠️ CAUTION

• Do not insert the microSD card at an angle. Doing so may cause damage.
• Ensure care is taken when handling the microSD card, as it could be hot.
• Do not remove the microSD card while the device is in operation.

Note

• Use a class 10 or above microSD card for proper functionality.
• You will not be able to record videos without a microSD card.
• You shall be prompted to format the microSD card after inserting it for the first time into the dash camera.

Installation

Specified Installation Position on Front Windshield

When installing this product in your vehicle, please be mindful of the position on the front windshield. Install in a way that satisfies any prescribed or applicable laws at your location and also following conditions:

• Install the product at a place where it doesn't obstruct any of the airbag deployment zone. The ideal location is behind the rear view mirror, out of the driver's view as shown in the illustration.
• Position the product so that it is within 20% of the top edge of the front windshield (approximately 20% of the windshield's height, excluding areas overlapping weatherstrips, moldings, etc., and masked parts) or in the shadow of the rear-view mirror as viewed from the driver's seat. Note that "20%" is a rough estimate; please install according to your location's laws and regulations.
• Position the product so that its lens is within the wiper's wiping range.
• Position the product so that its lens does not hang over the sunshade or black ceramic lines/pattern.
• Position the product to face horizontally towards the front and sides.
• Position the product where the cigarette lighter USB power cable can be routed without unnecessary force.

Always install the product in the specified position to ensure a safe field of view while driving and to achieve full performance. Pioneer is not liable for any damages due to faulty or improper installation or use of the product.

Installing the Dash Camera

1. Clean the installation area of dirt and oils using a clean cloth.
2. Install this product:
   • Peel off the double-sided tape release paper from the dash camera mount.
   • Install at the specified position on the front windshield. Firmly push the product onto the surface.
3. Connecting the cables:
   • Connect the power cable to the power adapter and main unit.
   • Route the power cable to the passenger seat side.
   • Route the rear camera cable via the ceiling only.
   • Connect the USB power adapter to the vehicle's cigarette lighter socket. Fully insert it into the vehicle accessory socket for a good connection (socket location may vary by vehicle).

⚠️ CAUTION

• Ensure the front windshield surface is clean and dry before attaching the dash camera mount.
• Use extreme care as the double-sided tape on the dash camera mount is very strong and should not be reapplied once applied.
• For optimal tape adhesion, it is recommended that the product remains undisturbed for about 24 hours after installation, avoiding any shocks during driving.

⚠️ CAUTION

• The accessory socket may become extremely hot immediately after connecting the adapter. The power cable tip may melt or short circuit if plugged in while the socket is hot. Ensure the socket is cool before plugging in the cigarette lighter power cable.
• Use only with a 12V vehicle accessory cigarette lighter socket or USB port to avoid damage/malfunction.

4. Adjust the angles of this product so that the video outside the vehicle is properly displayed.
5. Switch on the ignition to check if the installed product is working as expected.

Recommended Installation Position on Rear Windshield (for 2nd Camera)

A second camera (sold separately) is required for installation on the rear glass. If installing only this product, skip these instructions.

When installing the second camera (sold separately) on the inside of the rear window, it is recommended to install it in a position that satisfies all of the following conditions:

• Position the second camera (sold separately) so its lens is within the wiper's wiping range.
• Position the second camera (sold separately) horizontally towards the rear, with the lens centered on the rear windscreen.
• Position the second camera (sold separately) so its lens and the double-sided tape do not overlap the heating wires.
• Position the second camera (sold separately) so its connection cable can be routed without unnecessary force.

Installing the 2nd Camera (sold separately)

The orientation of the image (top/bottom) can be adjusted by mounting the second camera (sold separately).

1. Clean the installation area of dirt and oils using a clean cloth.
2. Install the 2nd camera (sold separately):
   • Peel off the double-sided tape release paper from the second camera's mount.
   • Orient the camera so its lens faces the outside of the vehicle, and install it at the specified position on the rear windshield.

   Turn the lens towards the outside of the vehicle and press firmly so that the image from the second camera (sold separately) is displayed horizontally.

⚠️ CAUTION

• Ensure the rear windshield surface is clean and dry before attaching the rear camera.
• Use extreme care as the double-sided tape on the rear camera is very strong and should not be reapplied once applied.
• To ensure the adhesive tape's strength, do not use the product for 24 hours after installation.

Note

• A protective film is applied to the lens when the product is purchased. Peel off this film.

Direct Connection with Vehicle Battery (Parking Mode)

Important: Disconnect the positive (+) terminal of the vehicle's battery before connecting the power cable.

Parking mode can be enabled on this dash camera. This requires purchasing a Hardwire Kit and having it installed by a trained automobile technician. By drawing power directly from the vehicle's battery, this product can detect and record vehicle movement caused by vibration even when the engine is turned OFF. It is recommended to use a power cable (or Hardwire Kit) with a fuse.

Wiring Diagram

Ground (Black): Securely connect to the metal part of the vehicle body. For noise prevention, connect as close to the navigation unit as possible.

+ Battery Power Supply (Yellow): Always connect to the power circuit supplied by the battery, regardless of whether the vehicle engine switch is ON or OFF.

Accessory Power Supply (Red): Connect to the power circuit that receives power when the vehicle engine switch is turned to the ACC position. Never install the accessory power supply to a vehicle without an ACC position on the engine switch, as this may lead to a dead battery.

Note:

Connect the red and yellow lead wires to the terminals after wiring through the vehicle's fuse unit.

Connection Precautions

To prevent fuming and damage, first securely connect the black lead wire (Ground) to the metal part of the vehicle body. For products with high current consumption (e.g., power amplifiers), use separate black lead wires (Ground). If connections are made simultaneously, there is a risk of fuming or product damage if screws loosen or come off completely.

• *1 Not supplied with the product.

Connecting to Dash Camera App

1. Scan the code to find the Companion App on Google Play or App Store.
2. Download the App.
3. Sign up and follow pairing instructions.
4. Default Wi-Fi Name (SSID): Pioneer_H320SC_XXXX
5. Default password: 12345678

Note

• XXXX shall be a unique alphanumeric entity.
• Supports Android™ OS version 11 & above, iOS version 13 & above.

Trademarks and Copyrights

• USB Type-C® and USB-C® are registered trademarks of USB Implementers Forum.
• IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.
• App Store is a service mark of Apple Inc., registered in the U.S. and other countries and regions.
• Android and Google Play are trademarks of Google LLC.
• microSD, microSDHC, and microSDXC Logos are trademarks of SD-3C LLC.