Living Spaces
Dante Sofa Sleeper
Parts List
- Part A: Sofa Legs (Quantity: 5) - [Description: A simple leg component.]
- Part B: Support leg (Quantity: 7) - [Description: A taller, cylindrical support leg.]
- Part C: Small screw (5x60mm) (Quantity: 22) - [Description: A standard screw.]
Assembly Instructions
Attaching Legs
Step 1: Attach the Sofa Legs (Part A) and Support Legs (Part B) to the underside of the sofa frame using the Small Screws (Part C). Ensure legs are securely fastened.
[Diagram Description: A view of the sofa's underside showing attachment points marked with 'A' and 'B'. Red arrows indicate where legs are to be attached, and blue arrows show screws being inserted into pre-drilled holes. A close-up view illustrates a screw being driven into a leg.]
Important Note: Before attaching new legs, remove any existing Sofa Legs (Part B) that may be attached to the base cloth zipper area.
Operation Instructions: Sofa Bed Conversion
Estimated time: 00:20 ⏰
Converting to Bed
- Step 1: Locate and cut the plastic tie on the bottom of the sofa bed.
- Step 2: Pull the two cloth straps outward. This action will extend the sofa bed horizontally. [Diagram Description: A side view of the sofa showing two cloth straps on the front of the seat being pulled outwards, causing the sofa bed frame to extend.]
- Step 3: Lift up the two cloth belts. This will allow the seat cushion to lay flat, completing the conversion to a bed. You can now enjoy the bed. [Diagram Description: A side view of the extended sofa bed. Two cloth belts are shown being lifted, which causes the seat cushion to flatten out.]
Converting Back to Sofa
Step 4: To close the sofa bed, reverse the steps. Push the bed mechanism back inside underneath the sofa until it is fully retracted.