Initial Setup
Follow these steps to set up your Traceable® 4-Channel Timer:
Remove the battery cover and insert the required batteries.
[Diagram: Illustration showing the back of the timer with the battery cover removed, indicating battery insertion points.]
Replace the battery cover.
[Diagram: Illustration showing the battery cover being closed.]
Press the CH/CLOCK button until the clock display appears on the top row of the screen.
[Diagram: Timer display showing 'CH1 CH2 CH3 CH4 CLOCK' and the time section, with the clock indicator active.]
Hold the CH/CLOCK button until an audible beep is heard and the time begins to flash.
To adjust the 12/24 hour clock format, press and hold the START/STOP ALL button.
Use the H (Hours), M (Minutes), and S (Seconds) buttons to adjust the time to the correct setting.
[Diagram: Close-up of the timer buttons labeled H, M, S, and START/STOP ALL, indicating their function in time adjustment.]
Note: Pressing the Seconds button will round the time to the nearest minute.
Press the CH/CLOCK button again to exit the setup mode and confirm the time.
Setting a Timer
Press the CH/CLOCK button repeatedly until the desired timer channel (CH1, CH2, CH3, or CH4) is highlighted or solid (not flashing) on the screen. This indicates it is selected for setting.
[Diagram: Timer display showing 'CH1 CH2 CH3 CH4 CLOCK' with one channel highlighted, and the time display.]
Use the H, M, and S buttons to set the desired time duration for the selected timer channel.
[Diagram: Timer display showing a selected channel and the time setting interface, with H, M, S buttons highlighted.]
Note: To clear a set timer and start over, press the CLEAR button.
Starting a Timer
To start/stop an individual timer: Navigate to the desired timing channel using the CH/CLOCK button, then press the START/STOP ALL button.
[Diagram: Timer display showing a selected channel, ready to be started or stopped.]
To start/stop all timers simultaneously: Ensure the display is on the main clock screen, then press the START/STOP ALL button.
[Diagram: Timer display showing the main clock screen, with the START/STOP ALL button highlighted.]
Timer Status Indicators:
- Timers that are actively counting down will flash quickly.
- Timers that are counting up will flash slowly.
- Timers that have finished their countdown (expired) will flash rapidly.
Warranty, Service, or Recalibration
For warranty, service, or recalibration inquiries, please contact:
Traceable®
An Antylia Scientific Company
12554 Old Galveston Rd. Suite B230
Webster, Texas 77598 USA
Phone: 281-482-1714
Fax: 281-482-9448
Email: support@traceable.com
Website: traceable.com
Traceable® Products are ISO 9001:2018 Quality-Certified by DNV and ISO/IEC 17025:2017 accredited as a Calibration Laboratory by A2LA.
Item No.: 56000-16
Model No.: 5667
©2022 1065T9_M_92-5667-00 Rev. 0 09022022