User Manual for Weiyucheng models including: 2BNI3-WY-030, 2BNI3WY030, wy 030, WY-030 Wireless Keyboard, WY-030, Wireless Keyboard, Keyboard
Shenzhen Jiuxingda Electronics Co., Ltd. WY-030 wireless keyboard 2BNI3-WY-030 2BNI3WY030 wy 030
File Info : application/pdf, 1 Pages, 28.69KB
DocumentDocumentWireless Keyboard User Manual(English) Getting Started Guide: 1. Power Button: slide switch ON or OFF to control the device power turn on or turn off. Connect Button: Under the power on, press the connect button, the keyboard will enter the BT connection preparation state. 2. Power indicator: turn on the power button on, The state indicator light will be on for 4 seconds, then the light will go off. BT connect indicator: Press on the [connect] button, the [BT] indicator light will be blinking, indicator light will stay on until the keyboard connect with your device. 3. Uppercase and lowercase indicator: Indicator light will stay on under the uppercase. 4. Charging indicator: When the battery is low, the power indicator light flashing. When charging "charge indicator" will light up, when the battery is full of "charge" will automatically lights go out. BT keyboard connection operation steps: 1. To set the keyboard power button to "ON" position, the power indicator light will light up for 4 seconds, and then Go out; Press the "Connect button" on keyboard, BT connection lights will twinkle, now keyboard can be connected to the tablet computer; 2. Open the tablet computer, Click on the "Settings" icon on the tablet computer. 3. Select "BT" in "Settings" interface, Enter the BT settings interface, Click on the BT switch to open the connection. 4. The tablet computer will automatically search is enabled BT devices, BT keyboard found signals, click it to connect. FCC Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. Important: Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.Microsoft Word 2019