ULINE 3-in-1 Wireless Charger

Introduction

This device is a versatile 3-in-1 wireless charger designed to power your mobile phone, Apple Watch, and earbuds simultaneously.

Specifications

• Type-C Input: 9V-3A
• USB-A Output: 5V-1A
• Wireless Charging Output:
  • For Mobile: 15W/10W/7.5W/5W
  • For Earbuds: 3W
  • For Apple Watch: 2.5W

Using the Wireless Charger

1. Connect the device to a power source using the included USB-C to USB-C cable and a PD30W wall adapter (not included).
2. Place your compatible phone onto the magnetic charging stand. The device will indicate when charging begins.
3. Position your Apple Watch on the designated charging area.
4. Place your earbuds on the charging pad. The device will indicate when charging begins.

Note: Ensure your phone and earbuds are compatible with wireless charging.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator and your body.