CAUTION: To reduce The Risk Of Fire And Electric Shock,. This Light Kit Should Be Used Only With The Fan Models. Listed Below: Models: AC-542/AC-552/AC-652/AC- ...
ASSEMBLY INSTRUCTIONS for Fan Light Kit, Model# K9363-L and K9372 READ AND SAVE THESE INSTRUCTIONS BE SURE TO FOLLOW ALL STEPS IN THE ORDER GIVEN. BE SURE POWER IS OFF AT FUSE, OR CIRCUIT BREAKER BOX. Attention: The Energy Policy Act of 2005 requires this light kit to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit will shut off automatically. CAUTION: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at fuse box. 1. Remove and discard the center plug from the switch cup. Attach the light kit to the switch cup by feeding the wires and threading the light kit through the hole of the switch cup, secure it to the switch cup by nut & lock washer. Be sure it is tight enough to prevent the light kit from vibrating loose. (Fig. 1) WIRE NUT NUT LOCK WASHER CENTER PLUG SWITCH CUP LIGHT KIT 2. Locate two single white and blue wires in the switch cup labeled "FOR LIGHT". 3. Make the wire connections as follows and secure with the wire nuts provided: - Connect white wire from switch cup to white wire from light kit - Connect blue wire from switch cup to black from light kit Fig. 1 4. Remove the screws from the switch cup plate. While holding the switch cup, firmly snap the wire molexes together. Next, slide switch cup up against plate and rotate it until the screw holes are aligned. Secure switch cup to plate using the screws removed earlier. (Fig. 2) 5. Slide the switch cup up over the switch cup plate and rotate until the screw holes are aligned. Secure the switch cup with three screws previously removed. (Fig. 2) SWITCH CUP PLATE MOLEX LIGHT KIT ASSEMBLY SCREWS CAUTION: Make sure that the wires are not pinched between the switch cup and the switch cup plate. 6. Install 3 candelabra bulbs (Max. 60W) (included). DO NOT EXCEED MAXIMUM WATTAGE RATING. Fig. 2 Note: Lamping in excess of 190 Watt will disable your light kit. To reset your light kit you must turn the power off and re-lamp keeping the wattage under 190 watts. 7. Remove the rubber washer, metal nut, glass cap and decorative nut from the light kit. Place glass shade over the light kit stem, secure with the rubber washer, metal nut, glass cap and decorative nut. Do not overtighten. (Fig. 3) Note: Make sure to leave enough space between the fan pull chain and the bulbs so the chain doesn't rub against any of the bulbs. CAUTION: To reduce The Risk Of Fire And Electric Shock, This Light Kit Should Be Used Only With The Fan Models Listed Below: Models: AC-542/AC-552/AC-652/AC-742. Manufactured By Air Cool Industrial Co, Ltd. Approximate maximum weight: K9363- L - 3.53 Lbs. K9372- 3.42 Lbs. BULBS LIGHT KIT GLASS SHADE RUBBER WASHER METAL NUT GLASS CAP Fig. 3 DECORATIVE NUT PULL CHAIN Manual design and all elements of manual design are protected by U.S. Federal and/or State Law, including Patent, Trademark and/or Copyright laws.Adobe Illustrator CS3 Acrobat Distiller 9.0.0 (Windows)