CoComelon 80-558100 Smart Wheels JJ's Tractor and Track Instruction Manual

Best Kids Tech Toys | Electronic Learning Toys | VTech America

PRODUCT FEATURES - VTech

CAN ICES-003(B)/NMB-003(B). 5. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of ...

Original Document

If the viewer doesn’t load, open the PDF directly.

Extracted Text

Go! Go! Smart Wheels�
Instruction Manual
TM
Battery Removal and Installation
1. Make sure the unit is turned Off. 2. Find the battery cover located on the
bottom of the unit, use a screwdriver to loosen the screw and then open the battery cover. 3. Remove old batteries by pulling up on one end of each battery. 4. Install 2 new AAA (AM-4/LR03) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.) 5. Replace the battery cover and tighten the screw to secure.

WARNING:
Adult assembly required for battery installation. Keep batteries out of reach of children.

ATTENTION :
Les piles ou accumulateurs doivent �tre install�s par un adulte. Tenir les piles ou accumulateurs hors de port�e des enfants.

WARNING: All packing materials such as tape, plastic sheets,

packaging locks, removable tags, cable ties, cords and

packaging screws are not part of this toy, and should be

discarded for your child's safety.

NOTE:

Please save this Instruction Manual as it contains

important information. ATTENTION : Pour la s�curit� de votre enfant, d�barrassez-vous de
tous les produits d'emballage tels que rubans adh�sifs, feuilles de plastique, attaches, �tiquettes, cordons et vis

d'emballage. Ils ne font pas partie du jouet.

NOTE :

Il est conseill� de sauvegarder ce manuel d'utilisation car

il comporte des informations importantes.

CoComelonTM & � 2022 Moonbug Entertainment. All Rights Reserved.

1

91-004198-002 CA

Unlock the packaging locks:
Turn the packaging lock counterclockwise several times. Pull out and discard the packaging lock.
IMPORTANT: BATTERY INFORMATION
� Insert batteries with the correct polarity (+ and -). � Do not mix old and new batteries. � Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries. � Only batteries of the same or equivalent type as recommended are
to be used. � Do not short-circuit the supply terminals. � Remove batteries during long periods of non-use. � Remove exhausted batteries from the toy. � Dispose of batteries safely. Do not dispose of batteries in fire. RECHARGEABLE BATTERIES � Remove rechargeable batteries (if removable) from the toy before
charging. � Rechargeable batteries are only to be charged under adult supervision. � Do not charge non-rechargeable batteries.
PRODUCT FEATURES
1. On/Off Switch
To turn the unit On, slide the On/Off Switch to the On position. To turn the unit Off, slide the On/Off Switch to the Off position.
2

2. Automatic Shut-Off
To preserve battery life, the Go! Go! Smart Wheels� vehicle will automatically shut off after approximately 60 seconds without input. The unit can be turned on again by pressing the Figure Button or triggering a Smartpoint� location. NOTE: This product is in Try-Me mode in the packaging. After opening the package, turn the vehicle off and on again or put the vehicle on Smartpoint� to proceed with normal play. If the unit powers down while playing, install a new set of batteries. NOTE: Ce produit est actuellement en mode D�monstration. Une fois d�ball�, veuillez l'�teindre puis le remettre en marche ou mettre le v�hicule sur une Zone Magique pour activer toutes ses fonctionnalit�s. Si le jouet s'�teint ou si les lumi�res faiblissent pendant le jeu, nous vous conseillons de changer les piles.
ACTIVITIES
1. Figure Button
Press the figure button to hear sounds, songs, phrases and melodies. A flashing light will accompany the responses.
2. SmartPoint� Locations
Put the vehicle on the SmartPoint� of the bundled track piece to see the light flash and to hear JJ talk, sound effects, short tunes and sing-along songs. For added fun, the vehicle also responds to other SmartPoint� locations of Go! Go! Smart Wheels� playsets (playsets sold seaprately).
3

CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth. 2. Keep the unit out of direct sunlight and away from any direct heat
sources. 3. Remove the batteries if the unit will not be in use for an extended period
of time. 4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow these steps: 1. Turn the unit Off. 2. Interrupt the power supply by removing the batteries. 3. Let the unit stand for a few minutes, then replace the batteries. 4. Turn the unit On. The unit should now be ready to use again. 5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or by going to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.
4

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
� Reorient or relocate the receiving antenna. � Increase the separation between the equipment and receiver. � Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. � Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Supplier's Declaration of Conformity 47 CFR � 2.1077 Compliance Information

Trade Name:

VTech�

Model:

5580/5581/5613/5614

Responsible Party: Address:

VTech Electronics North America, L.L.C. 1156 W. Shure Drive, Suite 200

Arlington Heights, IL 60004

Website:

vtechkids.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

CAN ICES-003(B)/NMB-003(B)

5

Visit our website for more information about our products, downloads, resources and more.
vtechkids.com vtechkids.ca
Read our complete warranty policy online at vtechkids.com/warranty vtechkids.ca/warranty
TM & � 2022 VTech Holdings Limited. All rights reserved. Printed in China.
91-004198-002 US CA