Vaporesso XROS 4 Mini Pod Kit User Manual

Introduction

Thank you for choosing a Vaporesso product. For correct and safe use of this product, please read this user manual carefully. If you have any questions, contact your supplier.

Basic Product Information

The Vaporesso XROS 4 Mini is a smaller version of the Vaporesso XROS 4 model. It introduces enhanced COREX 2.0 technology, providing a more intense flavor and a longer lifespan for the cartridges.

• Charging: USB-C port (5V / 2A)
• Material: Aluminum alloy + PCTG
• Airflow Adjustment: Yes
• Weight: 46.5 g

Note: This product is not intended for liquids containing nicotine.

Putting into Operation

Before first use, wait at least five minutes for the e-liquid to adequately saturate the coil within the cartridge.

Steps:

1. Fill the cartridge with e-liquid.
2. Remove the cartridge from the battery unit. Peel off the protective plastic film from the bottom of the cartridge.
3. Remove the mouthpiece. Fill the e-liquid through the filling port.
4. Replace the mouthpiece and attach the filled cartridge to the battery unit.

Diagram Description: The device components include a mouthpiece, a filling port, an airflow adjustment slider on the rear, an LED indicator, and a USB-C port. The preparation steps involve removing the mouthpiece, peeling off a protective film from the cartridge base, filling the e-liquid, replacing the mouthpiece, and attaching the cartridge to the battery.

Product Parameters

• Dimensions: 107.51 x 24 x 14.12 mm
• Inhalation Style: RDL (Restricted Direct Lung)
• Activation Method: Automatic draw activation
• Output Power: Automatic
• Battery Capacity: 1000 mAh
• Included Cartridge Resistance: 0.4 Ω
• Included Cartridge Volume: 3 ml

Airflow Adjustment

Use the slider located on the back of the e-cigarette to regulate the airflow, which influences the tightness of the draw.

Activation and Vaping

The XROS 4 Mini variant does not feature a power button. It is ready for operation immediately after filling and inserting the e-liquid cartridge.

To vape, place your lips on the mouthpiece and inhale. The draw will activate automatically.

Battery Status

You can monitor the current battery status by observing the color of the LED indicator during inhalation:

Charging

Connect the e-cigarette to a USB-C cable and then to a power adapter. The recommended adapter parameters are 5V / 2A. The adapter is not included in the package.

During charging, the LED indicator will change color according to the charge level. Once charging is complete, the indicator will remain green.

Safety Features

• Low Resistance / Short Circuit: The LED indicator will flash red 5 times, and heating will stop.
• High Temperature: The LED indicator will flash red 3 times consecutively. It will then turn off, flash red again, and heating will stop.
• Unrecognized Cartridge / High Resistance: The LED indicator will flash 4 times consecutively in a color corresponding to the battery level, and heating will stop.
• Low Voltage / Over-discharge Protection: The LED indicator will flash red 3 times, and heating will pause.
• Overcharge Protection: After successful charging, the green LED will remain lit, and the device will disconnect from charging.
• Timeout Protection (8-second limit): If an inhalation exceeds 8 seconds, the device will stop heating, the LED indicator will flash red 4 times consecutively, then turn off, and pulse once.

General Principles of Proper Operation

• Keep the contacts between the cartridge and the e-cigarette body clean. If any excess un-vaporized condensate appears on the contacts, wipe it off with a paper tissue.
• Always use e-liquids of appropriate viscosity to prevent potential leakage or spitting of e-liquid.
• Use a suitable charging source for charging.
• Do not expose the device to extreme temperatures, such as very low or high temperatures, or excessive ambient humidity. The recommended operating temperature range is 10 – 40°C, and the recommended storage temperature range is 10 – 40°C.
• Keep the e-cigarette/mod in sight while charging.
• Prevent possible falls and impacts to the e-cigarette/mod to avoid battery damage.

Important Information

SALE PROHIBITED FOR PERSONS UNDER 18 YEARS OF AGE.

Manufacturer and Importer Information

Manufacturer: Vaporesso (China)

Importer: 2Hservice s.r.o.
Address: Křivenická 444/33, Praha
Website: www.mastervaper.cz
Country: Czech Republic
Phone: +420 734 645 645

[CE certification mark] [recycling symbol]