Teltonika RUT955 Quick Start Guide v2.2

Device Overview

Front View

• LAN Ethernet ports
• WAN Ethernet port
• RS485 interface
• LAN LEDs
• WAN LED
• Power socket
• Mobile signal strength indication LEDs
• Power LED
• RS232 interface
• Input/output connector
• Mobile connection status LED

Back View

• Mobile AUX antenna connector
• GPS antenna connector
• Mobile MAIN antenna connector
• SIM holder (x2)
• USB connector
• WiFi antenna connectors
• SIM needle
• Reset button

Hardware Installation

Power Socket Pinout

• Power / Red wire
• Ground / Black wire
• Input / Green wire
• Output / White wire

Installation Steps

1. Push the SIM holder button with the SIM needle.
2. Pull out the SIM holder.
3. Insert your SIM card into the SIM holder.
4. Slide the SIM holder back into the router.
5. Attach all antennas.
6. Connect the power adapter to the socket on the front of the device. Then plug the other end of the power adapter into a power outlet.
7. Connect to the device wirelessly using SSID and password provided on the device information label or use an Ethernet cable connected to LAN port.

Login to Device

1. To enter the router's Web interface (WebUI), type http://192.168.1.1 into the URL field of your Internet browser.
2. Use login information shown in the example (Username: admin, Password: admin01) when prompted for authentication.
3. After login, you will be prompted to change your password for security reasons. The new password must contain at least 8 characters, including at least one uppercase letter, one lowercase letter, and one digit. This step is mandatory.
4. When you change the router's password, the Configuration Wizard will start.
5. Go to the Overview page and pay attention to the Signal Strength indication. To maximize cellular performance, try adjusting the antennas or changing the device's location to achieve the best signal conditions.

Login Example

Username: admin

Password: admin01

[Login Button]

Signal Strength Example

Mobile Signal Strength: -65 dBm

Data connection state: Connected

State: Registered (home); OPERATOR; 4G (LTE)

SIM card slot in use: Ready

Bytes received/sent: 348.7 KB / 223.5 KB

Technical Information

Radio Specifications

• RF technologies: 2G, 3G, 4G, WiFi, GNSS
• Max RF power: 33 dBm@GSM, 24 dBm@WCDMA, 23 dBm@LTE, 20 dBm@ WiFi

Bundled Accessories Specifications

• Power adapter: Input: 0.4A@100-240VAC, Output: 9VDC, 1A, 4-pin plug
• Mobile antenna: 698~960/1710~2690 MHz, 50 Ω, VSWR<3, gain** 3 dBi, omnidirectional, SMA male connector
• WiFi antenna: 2400~2483.5 MHz, 50 Ω, VSWR<2, gain** 5 dBi, omnidirectional, RP-SMA male connector
• GNSS antenna: 1575.42~1602 MHz, 2.2~5 VDC, VSWR<1.5, gain** 28 dB (typ.), RHCP polarization, SMA male connector

*Order code dependent.

**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.

Safety Information

RUT955 router must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments.

Declarations of Conformity

Hereby, TELTONIKA declares that this RUT955 is in compliance with the essential requirements and other relevant provisions of Directive CE/RED.

The full text of the EU declaration of conformity is available at the following internet address: https://wiki.teltonika-networks.com/view/RUT955_CE/RED

Note: This sign means that all used electronic and electric equipment should not be mixed with general household waste.

Note: This sign means that product meets the requirements of the applicable EU directives.