Netis NX30 Wireless Dual Band Router Quick Installation Guide

1. Package Contents

Ensure the following items are included in your package:

• Netis NX30 Wireless Dual Band Router
• Power Adapter
• Ethernet Cable
• Quick Installation Guide

[Image description: Visual representation of the router, power adapter, Ethernet cable, and guide.]

2. LED Explanation

Understand the status of your router through its LED indicators:

• Power LED: Indicates the router's power status.
• WAN LED: Indicates the status of the Internet connection.
• LAN LED(s): Indicate the status of connected devices via Ethernet ports.
• MESH LED: Indicates the status of the Easy Mesh connection.

[Image description: Diagram showing the router with labels pointing to each LED and a table or list explaining their states (e.g., solid, blinking, off) for different connection statuses.]

3. Hardware Connection

Follow these steps to connect your router:

1. Power off your modem.
2. Connect the WAN port of the Netis NX30 router to your modem's LAN port using the provided Ethernet cable. [Image description: Ethernet cable connecting modem to router's WAN port.]
3. Connect your computer to one of the LAN ports on the Netis NX30 router using another Ethernet cable. [Image description: Ethernet cable connecting computer to router's LAN port.]
4. Power on your modem first, wait for it to fully boot up, and then power on the Netis NX30 router. [Emoji: ?]

4. Configure the Router via Web Management Page

Set up your router's internet and Wi-Fi settings through the web interface.

1. Open a web browser on your connected computer.
2. Enter netis.cc or 192.168.1.1 into the address bar and press Enter. [Emoji: ?]
3. The router will attempt to detect your Internet access type. The default setting is Dynamic IP (DHCP).
4. Follow the on-screen prompts to configure your Wi-Fi network name (SSID) and password.
5. Complete the setup wizard. You should now be able to access the internet.

[Image description: Screenshots of the router's web interface showing the internet detection and Wi-Fi configuration steps.]

5. Easy Mesh Setup

Extend your Wi-Fi coverage using the Easy Mesh feature.

To set up Easy Mesh, press the WPS/MESH button on both the main router and the mesh unit simultaneously or follow the specific instructions for adding a mesh node.

[Image description: Visual showing the MESH button on the router and a separate mesh unit, with an arrow indicating simultaneous pressing.]

FCC Compliance Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• (1) This device may not cause harmful interference.
• (2) This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

Product Specifications (Metadata)