Melamine Worktop Care and Installation Guide
Material and Properties
The worktop is made of melamine laminate pressed onto particleboard. Melamine laminate is created by pressing together paper layers impregnated with melamine resin. This process, using heat and pressure, hardens the surface, resulting in a durable plastic finish upon cooling. Melamine laminate is suitable for surfaces requiring long-term resistance to daily wear and tear.
Note: Modifications to the worktop are not recommended unless necessary for installation and if edge covering is provided with the product. If edge covering is not included, modifications are strongly advised against.
Usage Advice
Before Installation
- Store the worktop in a room with normal temperature and humidity levels. Avoid placing it near a warm radiator or on a cold floor.
- When storing, stand the worktop on the back edge of its long side.
- Keep the plastic packaging on until ready for installation.
- Support legs are required if the overhang exceeds 25 cm. The maximum distance between support legs should not exceed 80 cm.
- Worktops installed above dishwashers, washing machines, or ovens must have their underside protected with FENSJÖ or FIXA diffusion barrier.
- Not suitable for use in wet rooms.
- Recommended for indoor use only.
Care and Maintenance
- For daily cleaning, use ordinary washing-up detergent, soap, or water. Never use chemicals.
- Wipe up spills immediately with a soft cloth dampened in water and mild detergent or soap.
- Do not use products containing abrasives, ammonia, or bleach. Dry with a clean, dry cloth.
- Do not place hot objects directly on the worktop; always use a pot stand.
- Always use a chopping board; never cut directly on the worktop with a knife.
- Avoid dragging objects with rough or uneven edges across the worktop, as this can cause scratches.
- Do not place heat-emitting appliances like toasters, coffee makers, or kettles directly over seams between two worktops, as heat can damage the seam.
- Never use steel wool, scouring pads, or similar abrasive products, as they can scratch the surface.
For Matt Black Surfaces Only
Marks and small scratches can be removed using a melamine sponge.
