JABLOTRON JA-111H TRB Bus Module for Wired Detectors

Introduction

This document has been machine-translated from the original English version. In case of ambiguities or discrepancies, please refer to the original version of the document. If you find any errors or have further questions, please contact technical support (contact details are provided at the end of this document).

The JA-111H TRB is part of the JABLOTRON system. It is used to connect a wired detector equipped with NC/NO outputs to the control panel bus. It supplies power to the detector and reports its activation, tampering, and faults. The module must be installed by a trained technician holding a valid certificate issued by an authorized dealer.

Installation

Important: When connecting the module to the system bus, always disconnect the power. ⚠️

The current consumption of the connected detector must not exceed 50 mA (the module's power supply output is not protected against overload).

It is designed to be installed inside a standard wired detector (with contact outputs), but thanks to extended wires, it can also be installed outside it in a protected installation box.

1. Install the module in a suitable location inside the detector or within a protected installation box near the detector. The wire can be extended up to 3 meters. When installing the module inside the detector, ensure it cannot cause a short circuit due to poor insulation.
2. Connect the wires to the detector (as shown in Figure 1).
3. Connect the bus cable and turn on the control panel power supply.
4. The control panel must be in service mode.
5. Close the detector cover with the module installed inside.

Figure 1: Module Wiring Diagram Description

The diagram illustrates the internal components and wiring connections of the module. It shows:

• 1 – Bus connectors
• 2 – Production code
• 3 – LEDs: A yellow LED indicates a fault or an unregistered device. A red LED flashes to indicate the activation of any input.
• 4 – Module wires: Refer to the table below for wire functions.

System Registration and Settings

Use the recommended software or application according to the control panel type – refer to the control panel manual.

Technical Specifications

Declaration of Conformity

JABLOTRON a.s. hereby declares that the product JA-111H TRB is in compliance with the relevant Union harmonisation legislation: Directives No. 2014/30/EU, 2011/65/EU. The original document of conformity assessment can be found at www.jablotron.com – in the Downloads section.

Disposal Information

Note: Proper disposal of this product helps conserve valuable natural resources and prevents potential negative effects on human health and the environment, which could otherwise be caused by improper waste handling. Return the product to the retailer or contact local authorities for more information on the nearest collection point.

Additional Information

You can get the electronic version of this document (available in other languages) or the version to be installed on the JA-100+ device by scanning the QR code provided. [QR code excluded as per instructions].