Onn. Wireless Earphones Quick Start Guide

Get to Know Your Wireless Earphones

• Speaker Diameter: 13 mm
• Charging Cable: USB A-C 254 mm (minimum)
• 22 hours of total playtime (with charging case)
• IPX4 waterproof rating for earphones, not for charging case
• Both earphones will auto-pause when you remove them from your ears. When you place earphones back into your ears, the music will auto-play.

What's in the Box?

• Earphones x1 pair
• Charging case x1
• USB A-C x1
• Quick Start Guide x1

Let's Get Started!

First Time Setup

Step 1: Put earphones into charging case and close the lid for initial activation.

Step 2: Open charging case lid to auto power-on and auto TWS pair.

Step 3: Connect to your device through Bluetooth wireless technology, search for the entry "onn. True Wireless ENC".

Power On/Off & Bluetooth Pairing

Power on/Mise sous tension

Open charging case lid. Earphones will auto-power on and connect to the last paired device.

If you are carrying your earphones without the charging case, press and hold for 5 seconds to manually power on/off.

Power off/Mise hors tension

Place earphones into charging case and close lid. Earphones will charge and disconnect from the paired device; once fully charged, earbuds will power off.

Pairing mode/Mode jumelage

If you want to pair with another device, please turn off Bluetooth from your last paired device if it is nearby, then open charging case lid for pairing. Now it can be searched by your other devices.

Enjoy Your Music & Take a Call

• Play/Pause (Incoming call: Answer/end call): Press 2 times
• Incoming call: Reject (Left side or Right side): Press for 1.5 sec
• Siri/Voice Assistant: Press 3 times
• Previous Track (Left side): Press & Hold for 1.5 sec
• Next Track (Right side): Press & Hold for 1.5 sec

Charge Your Earphones

Earphones charging/Chargement des écouteurs

Charging: Charge case red light blinks for 1.5s, blue light blinks for 1.5s, then light turns off (red light is Left, blue light is Right).

Case charging/Chargement du boîtier

Use charging cable (USB A-C). About 2 hours (5V 0.5A).

Charging: Red LED light is on. Fully charged: Blue LED light is on.

The Fine Print

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

ISED Compliance Statements

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.

Ver.01 11/15/21

IC:11136A-ONN69415

FCC ID: 2ALVK-ONN100069415