Atari 2600 Jr. Rev. A Disassembly
guide 79615 en Atari 2600 Jr. Rev. A Disassembly
Guide ID: 79615 - Draft: 2018-10-15
Atari 2600 Jr. Rev. A Disassembly
How to disassemble the Atari 2600 Junior to remove the circuit board.
Written By: Aislinn
This document was generated on 2020-11-14 02:33:45 PM (MST).
© iFixit -- CC BY-NC-SA
www.iFixit.com
Page 1 of 5
Atari 2600 Jr. Rev. A Disassembly
INTRODUCTION
Guide ID: 79615 - Draft: 2018-10-15
How to disassemble the Atari 2600 Junior to remove the circuit board.
TOOLS:
3/16" Phillips Head Screwdriver (1) Heavy-Duty Spudger (1)
This document was generated on 2020-11-14 02:33:45 PM (MST).
© iFixit -- CC BY-NC-SA
www.iFixit.com
Page 2 of 5
Atari 2600 Jr. Rev. A Disassembly
Step 1 -- Remove the base
Guide ID: 79615 - Draft: 2018-10-15
Remove 5 Phillips screws from base.
Step 2 -- Detach the Case
Use a metal or heavy duty spudger to unhook the 3 plastic clips holding the front of the case together.
Be careful not to break the plastic clips
While unhooking the center hook use another spudger to run along the top and bottom casing. This helps to get the clip lose.
Be careful not to pull the case apart quickly, there is a ribbon that is attached to the top and bottom.
This document was generated on 2020-11-14 02:33:45 PM (MST).
© iFixit -- CC BY-NC-SA
www.iFixit.com
Page 3 of 5
Atari 2600 Jr. Rev. A Disassembly
Step 3 -- Detach the Ribbon
Guide ID: 79615 - Draft: 2018-10-15
Detach the ribbon from the circuit board by gently pulling ribbon out from clip.
Step 4 -- Remove Circuit Board from Base
There are 2 clips holding the circuit board in place. Using a metal or heavy duty spudger release the clip on the left side. Remove the circuit board.
This document was generated on 2020-11-14 02:33:45 PM (MST).
© iFixit -- CC BY-NC-SA
www.iFixit.com
Page 4 of 5
Atari 2600 Jr. Rev. A Disassembly
Guide ID: 79615 - Draft: 2018-10-15
This document was generated on 2020-11-14 02:33:45 PM (MST).
© iFixit -- CC BY-NC-SA
www.iFixit.com
Page 5 of 5
wkhtmltopdf 0.12.5 Qt 4.8.7