PAWBOL Electrical Distribution Board User Manual

Introduction

The PAWBOL Electrical Distribution Board is designed for the safe and reliable management of electrical power distribution in low-voltage installations. To ensure safe use, please read this manual carefully before first use. The electrical distribution board is intended for installation and operation by qualified personnel and must be used in compliance with applicable electrical standards and regulations.

Product Purpose

The electrical distribution board is used for distributing electrical power in low-voltage installations. It can be used in residential, industrial, and office buildings, as well as in infrastructure facilities.

Do Not Use In

• Installations with voltage higher than specified in the product specifications.
• Conditions where the board is not adequately protected against moisture or dust (refer to IP protection rating).

Technical Specifications

• Maximum rated voltage: As specified on the label.
• Maximum rated current: As specified on the label.
• Protection rating: As specified on the label.
• Protection devices: As specified on the label.

Installation and Mounting Instructions

Preparing the Installation Site

Choose a location that is dry, clean, and well-ventilated. Ensure the area around the board provides easy access to all components for maintenance and repairs. Verify that the electrical installation at the site meets the distribution board's requirements (e.g., voltage, current, load).

Wall Mounting

Drill mounting holes in the wall or surface where the board will be installed. Mount the board using appropriate brackets or screws, ensuring it is securely fixed. Connect the power supply cables to the board's input, following the electrical connection instructions (maintain correct polarity and torque settings).

Connecting Circuits

Connect individual circuits to the appropriate terminals in the board. Install the appropriate protective devices for each circuit (e.g., circuit breakers, fuses, residual current devices) as per the electrical installation design. Verify all connections before powering on the board.

Usage Instructions

Switching On and Off

To switch on the board, ensure all connections are properly secured and protected. Turn on the main power switch. To switch off the board, turn off the main power switch first, then the individual circuits.

Using Devices with the Distribution Board

Use only devices and electrical accessories designed for operation with the board. In case of device failure or a power outage, check the condition of the circuits and protections before restarting.

Warnings and Precautions

• Only qualified personnel should operate the board.
• Ensure power is turned off before performing any work on the board.
• Do not tamper with the board's components while it is powered.
• Verify that all connections are securely fastened.
• In case of malfunction or visible damage, contact technical support.

Maintenance

• Regularly inspect the condition of circuits and protections.
• Perform periodic cleaning of the board's exterior (e.g., dust removal), especially for boards with IP protection. Use a dry cloth for cleaning.
• Check for loose or damaged wires.
• Discontinue use immediately if damage is detected and replace faulty components.

Disposal

Products marked with a crossed-out bin symbol must not be disposed of with household waste. After end-of-life use, dispose of the board at an electronic waste collection point in compliance with electronic waste management regulations.

Manufacturer

PAWBOL S.A.
ul. W. Grabskiego 29,
32-640 Zator
Tel: +48 (33) 870-12-05
Email: firma@pawbol.pl

Note: The manufacturer is not responsible for damages resulting from improper installation, use, or repair of the product.