Nokia xx Quick Start Guide

Phone Overview

Your Nokia xx phone features the following components:

Front: Earpiece, Front camera, Flash, Fingerprint sensor, Microphone, Google Assistant/Google Search key*, USB connector.

Top: Microphone.

Side: Volume keys, Power/Lock key.

Back: Camera.

Other: SIM and memory card slot, Headset connector.

*Google Assistant is not available in certain languages and countries. Where not available, Google Assistant is replaced by Google Search. Check availability at https://support.google.com/assistant.

Getting Started

1. Insert the SIM and memory card

Follow these steps to insert your SIM card(s) and optional memory card:

1. Open the SIM card tray: push the tray opener pin into the tray hole and slide the tray out.
2. Place your nano-SIM card in the SIM slot on the tray with the contact area facing down.
3. If your phone supports dual-SIM, place the second SIM card in the SIM2 slot. Tip: Check the sales box label for 2 IMEI codes to confirm dual-SIM capability.
4. If you have a memory card, place it in the memory card slot.
5. Slide the tray back into the phone.

Important Notes:

• Use only original nano-SIM cards. Incompatible SIM cards may damage the card or the device and corrupt stored data.
• Use only compatible memory cards approved for this device. Incompatible cards may damage the card and device and corrupt stored data.
• ? Important: Do not remove the memory card while an app is using it. Doing so may damage the memory card, the device, and corrupt stored data.

Both SIM cards can be used simultaneously when the device is idle. However, when one SIM card is active (e.g., during a call), the other may be unavailable.

2. Charge the battery and switch the phone on

To charge your phone:

1. Plug a compatible charger into a wall outlet and connect the cable to your phone's [USB-C connector].
2. You can also charge from a computer using a USB cable, though this may take longer.

If the battery is completely discharged, it may take several minutes for the charging indicator to appear.

To switch your phone on:

• Press and hold the power key until the phone vibrates. The phone will then guide you through the setup process.

For an online user guide and troubleshooting help, visit www.nokia.com/mobile-support.

Note on Connectors: This phone uses a [USB-C connector] for charging. A [USB micro-B connector] is shown for reference but is not used for charging this device.

Product and Safety Information

For detailed information on the safe use of your device and battery, please refer to the separate Product and safety info booklet.

Network Compatibility: Your device supports GSM 850, 900, 1800, 1900; WCDMA 1, 2, 4, 5, 8; and LTE 1, 2, 3, 4, 5, 7, 8, 12, 13, 17, 28, 66 networks. A subscription with a service provider is required.

4G/LTE Service: Ensure your network service provider supports 4G/LTE, especially when traveling. If full 4G/LTE service is unavailable, you may need to switch your preferred network type to 3G via Settings > Network & Internet > Mobile network > Advanced.

Battery: The device has an internal, non-removable, rechargeable battery. Do not attempt to remove it or the back cover. For battery replacement, contact an authorized service facility.

Chargers: Use compatible chargers such as CH-21E (EU), CH-21X (UK), CH-21U (US), CH-21A (Australia), CH-21N (India), or CH-21B (Brazil). Other chargers or accessories may be sold separately.

Device Properties: The device surface is nickel-free. Parts of the device are magnetic; keep credit cards or magnetic stripe cards away to prevent damage.

Memory: Pre-installed system software and apps use a significant portion of the device's memory.

Flash Usage: Keep a safe distance when using the flash. Do not use the flash directly on people or animals at close range. Do not cover the flash while taking a photo.

SAR Certification Information

This mobile device complies with radio wave exposure guidelines set by the Federal Communications Commission (FCC) and Industry Canada (IC).

FCC RF Exposure: The device is designed not to exceed FCC emission limits for radio frequency (RF) energy. The Specific Absorption Rate (SAR) limit set by the FCC is 1.6 W/kg. The highest reported SAR values for this model are 0.99 W/kg (at the ear) and 0.95 W/kg (when worn on the body with a 1.0 cm separation distance).

To maintain compliance with FCC RF exposure requirements, use accessories that keep the handset at least 1.0 cm from your body. Accessories should not contain metallic components.

SAR information can be found on the FCC website by searching for FCC ID 2AJOTTA-1333 or 2AJOTTA-1340. Additional info is available at www.fcc.gov/general/radio-frequency-safety-0.

IC SAR: Information on IC SAR compliance can be found at http://www.ic.gc.ca.

General RF Exposure: The World Health Organization (WHO) states that current scientific information does not indicate a need for special precautions when using mobile devices. For reduced exposure, limit usage or use a hands-free kit. More information is available at www.who.int/peh-emf/en.

Body-worn Operation: This device was tested for typical body-worn operations with the handset kept 1.0 cm from the body. To maintain compliance, use accessories that maintain this separation distance.

Network Connection: A good network connection is needed for sending data or messages. Sending may be delayed until a connection is available. Follow separation distance instructions until sending is finished.

During general use, SAR values are typically lower than the stated limits due to automatic power reduction when full power is not needed.

Copyrights and Other Notices

FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) ✔️ this device may not cause harmful interference, and (2) ✔️ it must accept any interference received, including interference that may cause undesired operation. For more information, visit www.fcc.gov/engineering-technology/electromagnetic-compatibility-division/radio-frequency-safety/faq/rf-safety.

Any modifications not expressly approved by HMD Global may void the user's authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, providing reasonable protection against harmful interference in residential installations.

If interference occurs, try measures such as:

• ✔️ Reorient or relocate the receiving antenna.
• ✔️ Increase the separation between the equipment and receiver.
• ✔️ Connect the equipment to an outlet on a different circuit than the receiver.
• ✔️ Consult a dealer or experienced radio/TV technician.

IC Notice: Innovation, Science and Economic Development Canada (ISED) CAN ICES-3(B)/NMB-3(B).

Canadian Notice: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation.

Caution: Exposure to Radio Frequency Radiation:

• To comply with Canadian RF exposure requirements, this device and its antenna must not be co-located or operated with any other antenna or transmitter.
• A separation distance of at least 1.0 cm must be maintained between the antenna and all persons.

The device uses low-gain integral antennas that do not exceed Health Canada limits for RF fields. Consult Safety Code 6 from Health Canada's website at http://www.hc-sc.gc.ca/.

This device has an electronic label for certification information. Access it via Settings > System > Certification.

© 2020 HMD Global. HMD Global Oy is the exclusive licensee of the Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation.

Qualcomm aptX™ Adaptive is a product of Qualcomm Technologies, Inc. and/or its subsidiaries. Qualcomm is a trademark or registered trademark of Qualcomm Incorporated. aptX is a trademark or registered trademark of Qualcomm Technologies International, Ltd. Android, Google and other related marks and logos are trademarks of Google LLC.