Galanz GLR16FS2E16 Refrigerator Instruction Manual

Product Overview

The refrigerator features the following components:

• 1. Door Bin
• 2. Glass shelf
• 3. Crisper
• 4. Freezer upper drawer
• 5. Freezer lower drawer

Safety Warnings

General Safety Precautions:

• The refrigerator operates on a 120V single-phase AC power supply with a 60Hz frequency. Use a dedicated socket (above 10A) that is reliably grounded. Do not remove the third pin (ground wire) of the power cord. Ensure the power cord plug is firmly in contact with the socket to prevent fire hazards.
• When the refrigerator is not in use, remove the door and door seal to prevent children from getting trapped inside.
• Always unplug the power before cleaning and maintenance to avoid electric shock.
• Do not place electrical appliances such as power outlets, regulators, microwave ovens, or unstable items on top of the refrigerator. Electrical appliances are not permitted inside the refrigerator unless recommended by Galanz.
• Do not pull the power cord to unplug the refrigerator. When moving the refrigerator, operate carefully. Do not roll over or damage the power cord. If the power line or plug is damaged, it must be replaced by the manufacturer's designated repair point.
• Do not dismantle or modify the refrigerator, or damage the refrigerant line. If the refrigerant line is damaged or a combustible gas leaks, close the leakage valve, open doors and windows, and contact the manufacturer's specified repair points immediately.
• Do not place glass bottles or cans with liquid in the freezer to prevent bursting.
• Watch out for children and ensure they do not play in or on the refrigerator.
• Do not touch the cold surfaces in the freezer compartment, as this can cause frostbite due to low temperatures.
• Caution: The appliance contains a flammable refrigerant (R600a). Do not expose it to high heat, sparks, or open flames.

Precautions for Different Compartments:

• Refrigerating temperature: 39°F to 46°F. Cooked meat should not be stored for more than 4 days; fruits and vegetables should not exceed one week.
• Raw meat and seafood should be packed in separate containers and stored for no more than 3 days.
• Raw food and cooked food should be stored in separate containers to prevent bacterial contamination. Raw vegetables and fruits should not be exposed to raw meat or fish. Wrap vegetables and fruits in film and store them in the crisper.
• Before freezing food, wrap it in freezer-safe bags or containers. The freezer temperature is -0.4°F. For optimal taste and nutrition, food should not be stored in the freezer for more than three months.

Handling and Placement

Placement:

• Place the refrigerator on a flat, solid surface.
• Do not use the foam pad to elevate the refrigerator. Adjust the feet at the front to level the unit. Clockwise rotation raises the height; counterclockwise rotation lowers it.
• Avoid placing the refrigerator in wet areas or areas where temperatures may drop below 41°F.
• Ensure adequate ventilation: maintain at least 1/4 inch of space on the sides and back, and over 1 inch of space on top.
• Keep the refrigerator away from heat sources and direct sunlight to maintain optimal performance.
• Do not lift the refrigerator sideways or upside down. If tilting is necessary, the inclination should not exceed 45 degrees. Avoid using mobile pulleys on scratched floors.
• The refrigerator uses R600a refrigerant, which is flammable. Avoid collisions or violent shocks during transportation and placement to prevent damage to the refrigeration system or fire hazards.

Moving the Refrigerator:

• Before moving, unplug the power cord and remove all food.
• Secure movable parts like glass shelves, crispers, and drawers with tape. Close and tape the doors to prevent them from opening.
• Do not lift the refrigerator by the handles. Lift it from the bottom.
• Refrigerators cannot be transported upside down or laying flat. If transported incorrectly, allow the unit to stand upright for 2 hours before plugging it in.

Responsible Disposal:

• Do not dispose of the appliance with household trash at the end of its life. It contains materials that can be hazardous to the environment and human health if not disposed of properly.
• Follow local regulations for the disposal and recycling of electrical consumer goods and refrigerants. Contact local authorities for recycling facility information.
• Take care not to damage the pipework at the back of the appliance during transportation to prevent refrigerant gas escape. Render the plug useless and cut the cable directly behind the appliance to prevent misuse.
• DANGER: Risk of child entrapment. When discarding a refrigerator, remove the door and the spring action or bolt catch. Leave shelves in place to prevent children from climbing in and getting trapped.

Instruction for Usage

Initial Setup:

• After stable placement and cleaning, allow the refrigerator to stand for at least 2 hours before switching on the power.
• Ensure the refrigerator is placed in the correct location and is clean before use.
• The power cord should not be pressed by the refrigerator or other heavy objects.
• The refrigerating chamber temperature is typically 32°F to 50°F for short-term storage of fresh food like vegetables, fruits, and beverages.
• Wrap refrigerated food in plastic wrap and place it evenly on shelves to prevent odor transfer or moisture evaporation.
• Do not overfill the refrigerating chamber; allow space for cold air circulation.
• Cool hot food to room temperature before placing it in the refrigerator.
• Cut off leaves from radishes or similar foods to prevent nutrient absorption by the leaves.
• Do not exceed the freezer's freezing capacity.
• Minimize door openings to reduce cold air loss and extend storage time.
• Ensure food does not obstruct air outlets to maintain proper cool air circulation.
• Do not refreeze thawed frozen foods; consume them as quickly as possible.
• Use sealed packages or fresh-keeping bags for freezing to prolong storage and prevent freezer burn.
• In case of a power outage, reduce door openings and avoid adding new food.
• If a prolonged power outage is expected, place ice cubes in a watertight container in the upper part of the refrigerating chamber.

Usage Instructions:

• When the refrigerator is not in use, open the door to prevent odors from residual food.
• The freezing drawer is for long-term storage of items like meat and fish.
• Package food flat for freezing and thawing.
• After unplugging, wait at least 5 minutes before re-energizing.
• Wash and dry food before storing.
• If the refrigerator is to be stopped for a long time, unplug it, clean it, and do not block ventilation to maintain its service life.

Maintenance and Cleaning:

• Clean the refrigerator regularly to prevent unpleasant odors.
• Always unplug the refrigerator before cleaning.
• Use a soft towel or sponge with warm water and neutral detergent to clean the cabinet, avoiding the door seal. Clean the door seal with rinsing and a dry cloth.
• Note: Do not spray water directly onto electrical components. Use a dry rag for cleaning switches and lights.
• Note: Do not use hard brushes, wire brushes, gasoline, lacquer thinner, acetone, hot water, acid, or alkali for cleaning.

Defrost:

• This refrigerator is frost-free; manual defrosting is not required.

Door Handle Installation

1. Before installing the refrigerator door handle, locate the anchor bolts in the accessory bag. Perform all steps simultaneously on the right and left mounting positions.
2. Screw the locating bolt into the designated hole on the door body and secure it.
3. Loosen the locking screw inside the handle part with a hexagonal wrench. Align the handle with the positioning bolt and insert it. The handle locking screw should face downwards.
4. Ensure the handle fits perfectly with the door body, then use a hexagonal wrench to tighten the locking screw inside the handle part.
5. Complete the handle installation.

Door Mullion

When the door mullion is unfolded as shown in figure 1, the door may not close properly. Fold the door mullion inside as shown in figure 2 before closing the door to prevent damage. Do not force the door closed when the mullion is unfolded.

Note: The door mullion has a heater to prevent condensation. This heating is normal and does not affect frozen food.

Installing Door Bin

1. Place the tray above the mounting position and push the door down until it cannot move further to complete the installation.

Button Instruction of Display

The electronic display shows refrigeration and freezing temperatures.

Button Functions:

• Fridge Button: Adjusts the setting temperature of the refrigerating chamber.
• Freezer Button: Adjusts the setting temperature of the freezing chamber.
• Select Button: Cycles through function icons (quick freezing, intelligence) within 5 seconds.

Setting the Refrigerator Compartment:

• When the door is open, the LED display brightens. Press the “Fridge” button. The buzzer will sound, and the refrigerating room will enter the setting condition. The temperature patterns will flash, and the temperature will increase by 1°F. The temperature cycles from 33°F to 45°F.
• Warning: The temperature will be set automatically after 5 seconds of inactivity.

Setting the Freezing Room:

• When the door is open, the LED display brightens. Press the “Freezer” button. The buzzer will sound, and the freezing room will enter the setting condition. The temperature will flash, and the temperature will increase by 1°F. The temperature cycles from -5°F to -8°F.
• Warning: The temperature will be set successfully after 5 seconds of inactivity.

Setting of the Functions

• To enter function setting mode, push the “Select” button when the door is open.
• Quick Freezing Mode: Push “Select”. The quick freezing pattern will flash. This mode automatically exits within 24 hours after freezing is complete.
• Smart Mode: Push “Select”. The smart pattern will flash. In this mode, the refrigerator automatically adjusts temperatures based on environmental conditions.
• Note: In quick freezing mode, the freezer temperature is fixed and cannot be regulated.
• Note: In smart mode, the refrigerator and freezer temperatures adjust automatically based on the ambient temperature.
• Warning: Pressing “Select” again will exit the setting mode and return to automatic temperature regulation.

Humidity Control:

• The humidity control allows adjustment of moisture levels in the crisper. Slide the module left for lower humidity and right for higher humidity.

Lighting and Its Replacement

• The LED light turns on when the refrigerator door opens.
• If the lighting is damaged, remove the lampshade first, then replace the LED lighting.
• Steps for Replacement:
  1. Gently move the lampshade and thermostat 3-5mm in the direction of the arrow.
  2. Take out the lampshade and thermostat downwards.
  3. Pull the connection terminal and use a screwdriver to remove the LED light board for replacement.
• Note: If the LED lamp is abnormal, it should be replaced by a professional. Do not attempt to dismantle and replace it yourself to avoid damage.

Troubleshootings

Refrigerator doesn't work:

• Check if the refrigerator is properly plugged in.
• Verify if the supply voltage is too low.

Unusual smell in the refrigerator:

• Check if odorous food is wrapped tightly.
• Check for spoiled food.
• Clean the interior of the refrigerator.

Temperature inside the cabinet is not low enough:

• Ensure the door is closed tightly and minimize frequent opening.
• Check if the air outlet is blocked by food.
• Ensure the refrigerator is not placed under direct sunlight or near heat-producing appliances.
• Verify proper ventilation around the sides and back of the cabinet.
• Adjust the temperature setting to a lower level.

Lighting doesn't work:

• Check if the LED lamp (bulb) is damaged.
• Verify if the refrigerator is properly connected to the power supply.

Compressor runs for a long time:

• This is normal during initial operation or when a large amount of food is added.
• High ambient temperature can also cause longer compressor run times.
• Frequent door openings or a door not closing tightly can lead to longer run times.
• Setting the temperature too low can also cause the compressor to run longer.

Refrigerator is noisy when running:

• Ensure the floor is flat and the refrigerator is stable.
• Check if any part of the refrigerator is touching external objects or walls.

Note: If problems persist after troubleshooting, contact the after-sales service department or an authorized maintenance department.

Specifications and Parameters

Packing List

Limited Warranty

In-Home Service Full One Year Warranty:

Galanz will repair or replace any part, including labor, free of charge for 12 months from the date of original retail purchase if the part fails due to a defect in materials or workmanship. Galanz may, at its sole discretion, replace or repair any part or subsystem, including the entire product. The product must be accessible and installed properly to receive warranty service.

Warranty Commencement:

The warranty commences on the date of purchase. The original purchase receipt must be presented for warranty repairs.

Exceptions: Commercial Use Warranty:

• Labor: 90 days from date of original purchase.
• Parts: 90 days from date of original purchase.
• No other warranty applies.

For Warranty Service:

All service must be performed by a Galanz authorized service center. Call 1-800-562-0738. Have the following information ready: model number, serial number, dealer name and address, date of purchase, a clear description of the problem, and proof of purchase (sales receipt).

This warranty covers home appliance services within the contiguous United States, Alaska, Hawaii, and Puerto Rico.

What is not covered by this warranty:

• Replacement or repair of household fuses, circuit breakers, wiring, or plumbing.
• Products with removed or altered serial numbers.
• Service charges not identified as normal (e.g., normal service area or hours).
• Replacement of light bulbs.
• Damage to clothing.
• Damage incurred in shipping.
• Damage caused by improper installation or maintenance.
• Damage from misuse, abuse, accident, fire, flood, or acts of nature.
• Service performed by non-authorized Galanz dealers or service centers.
• Damage from incorrect electrical current, voltage, or supply.
• Damage resulting from unauthorized product modification, alteration, or adjustment.
• Adjustment of consumer-operated controls as identified in the owner's manual.
• Hoses, knobs, lint trays, attachments, accessories, and disposable parts.
• Labor, service transportation, and shipping charges for parts replacement beyond the initial 12-month period.
• Damage from other than normal household use.
• Transportation and shipping charges.

Limitation of Liability:

This limited warranty is in lieu of all other warranties, express or implied, including warranties of merchantability and fitness for a particular purpose. The remedy provided is exclusive. This warranty does not cover incidental or consequential damages. State laws may vary regarding limitations on implied warranty duration.

Warranty Registration

Please mail this warranty card within 30 days of purchase to:

Galanz Americas, 55 Challenger Road, Suite 503, Ridgefield Park, NJ 07660.

PLEASE PRINT CLEARLY:

• Name: _________________________
• Address: _________________________
• City: ________ State: ____ ZIP: ______
• Phone: ____________ Email: ____________
• Model Number: _________________________
• Serial Number: _________________________
• Purchase Location: _________________________

You must attach a copy of your purchase receipt to validate your registration.