OttLite Recharge LED Desk Lamp User Manual and Setup Guide

Congratulations!

OttLite Technologies is pleased to welcome you to the world of natural lighting technology with your new OttLite® product.

WARNING: To prevent electric shock, ensure the lamp is not plugged in until all setup steps are complete.

NOTE: THIS UNIT IS FULLY ASSEMBLED.

Remove the lamp from its packing and place the lamp body base (A) flat on a steady surface.
Connect the power adapter input (F) into the connector (G) located at the rear-bottom of the lamp.
Plug the power adapter (H) into a standard household 120V AC outlet.
Note: Only use the supplied power adapter to avoid damage or fire.
The power switch (B) is a "touch" switch that controls ON/OFF power and the LED brightness settings of the lamp.
To adjust LED settings, lightly touch the switch as follows:
- To turn the lamp "ON" to the 1st brightness setting: touch the switch once.
- For the 2nd brightness setting: touch the switch two times.
- For the 3rd brightness setting: touch the switch three times.
- To turn the lamp "OFF": touch the switch four times.
Charge the product using the included USB cable (K) or AC adaptor (H). It will take approximately 3.5 to 4 hours to fully charge the lamp. The LED indicator (J) will change from RED to GREEN when the lamp is fully charged.
Note: The lamp battery charge will last approximately two hours.
To reposition the light, hold the lamp base (A) steady and grasp either the flex-neck (C) or the shade (D) depending on the needed adjustment.
Refer to the diagrams for the lamp's maximum adjustment range.
Note: DO NOT FORCE the shade outside its allowable adjustable range, as excessive adjustment may cause damage.

Lamp Components and Adjustment

Diagram 1: Lamp Components and Tilt Range

A: Lamp Body Base
B: Power Switch (Touch Control)
C: Flex-Neck
D: Lamp Head/Shade
E: LED Panel
F: Power Adapter Input
G: Connector for Power Adapter
H: AC Adapter
J: LED Indicator (Charging Status)
K: USB Cable

The lamp head (D) can tilt approximately 35° from its vertical position, as indicated by the dashed line and angle symbol.

Diagram 2: Flex-Neck Adjustment Range

The lamp's flex-neck (C) allows for a wide range of motion, approximately 150°, enabling various lighting angles and positions.

Safety Warning: To Reduce the Risk of Fire, Electric Shock, or Injury to Persons

Turn the lamp off and WAIT UNTIL THE LAMP HEAD (D) IS COOL before handling.
The LED panel (E) might get hot after several hours of continuous use. DO NOT place your hands directly on the LED light panel.
Never use the lamp with an extension cord unless the plug can be fully inserted into the receptacles in the extension cord.
Do not alter the plug.
The lamp head included with this unit cannot be replaced by the consumer.
INDOOR USE ONLY.

Note: The important safety instructions appearing in this instruction sheet are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution, and care must be used with any electrical product.

CAUTION! If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or its service agent or a similar qualified person in order to avoid a hazard. INDOOR USE ONLY.

CAUTION! The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.

FCC Part 15 Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that of the receiver.
Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Any change or modification to the product not expressly recognized by OttLite Technologies voids OttLite's responsibility for proper function of the product.

CAN ICES-005 (B)/NMB-005 (B)

CAUTION! This product contains a built-in Lithium-Ion (Li-ion) battery. This is a non-replaceable battery. In the event of a faulty battery, the entire product shall be properly disposed of in accordance with local regulations for disposal of hazardous materials.

Li-ion Battery Information

Model: TY-18650-2000mAh
Capacity: 2000mAh (3.7Wh)
Output Voltage: 3.7V

NOTICE:

Never disassemble the battery yourself.
Use only the authorized charger.
Exposure of the battery to open flames could cause explosion.
Do not expose the battery pack outside the temperature range of 32°F to 113°F (0°C~45°C).

MADE IN CHINA

Specifications

Category	Detail
USB	5V, 500mA / Input power: 5V/500mA
Battery	Lithium, 3.7V / 2000mAh (power for LED Lights)
AC Adapter	Input: 100-240V, 50/60 Hz, 0.2A / Output: 5.0V DC, 1A

Accessories

USB Cord
A/C Adaptor

	OttLite Recharge LED Desk Lamp User Manual and Safety Information Comprehensive guide for the OttLite Recharge LED Desk Lamp, covering setup, operation, safety warnings, FCC compliance, and specifications. Includes model numbers CS59G59, CS59G59-SHPR, CS59089-SHPR.
	OttLite Creative Curves LED Desk Lamp User Manual and Safety Information User manual and safety guide for the OttLite Creative Curves LED Desk Lamp, covering assembly, operation, safety warnings, FCC compliance, and AC/DC adapter specifications. Includes model numbers CSA30WGC, CSA30WTC, and more.
	OttLite Slimline LED Desk Lamp: User Manual and Setup Guide Get detailed setup instructions, operation guidance, safety warnings, and FCC compliance information for the OttLite Slimline LED Desk Lamp (models CS33600C, CS336G5C). Learn how to adjust brightness and color temperature.
	OttLite Refine LED Desk Lamp User Manual Learn how to set up, operate, and adjust your OttLite Refine LED Desk Lamp (Models F1D83BN9, F1D83BR9, F1D83BN9-SHPR, F1D83BR9-SHPR). This manual includes safety warnings, FCC compliance, and product features like adjustable brightness and a USB charging port.
	OttLite Renew LED Desk Lamp User Manual and Setup Guide Comprehensive user manual for the OttLite Renew LED Desk Lamp, covering assembly, operation, calendar and clock settings, alarm functions, brightness adjustment, battery replacement, and important safety warnings, including FCC compliance.
	OttLite 13W Magnifier Task Lamp: Assembly, Use, and Safety Instructions Learn how to assemble, use, and maintain your OttLite 13W Magnifier Task Lamp. This guide includes important safety instructions, tube replacement steps, and FCC compliance information for models like OTL13MAGWT and OTL13MAGTU.
	OttLite Extended Reach LED Desk Lamp: Setup, Operation, and Safety Guide Comprehensive instructions and safety guidelines for the OttLite Extended Reach LED Desk Lamp, including assembly, operation, and FCC compliance information. Learn how to set up and use your lamp safely.
	OttLite Natural Daylight LED Flex Lamp User Manual Instructions and safety information for the OttLite Natural Daylight LED Flex Lamp, including assembly, operation, and FCC compliance.