SONGMICS Jewelry Cabinet - Installation and Safety Guide

General Guidelines

Please read the following instructions carefully and use the product accordingly. Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed.

Notes

The product is mainly used as a mirror and storage cabinet. The user must strictly assemble and use the product in accordance with the provisions of the manual. The seller does not assume any responsibility or liability with respect to any damage caused by incorrect assembly or improper use.
Please check if the cabinet body is intact and if accessories are complete before mounting. Do not place the edge of the unwrapped cabinet on the floor to avoid fraying or damage.
When mounting the wall cabinet, please make sure that the holes are away from electrical wires or water pipes, in order to prevent unexpected damage or losses.
Follow the assembly steps shown in the diagram to position and adjust the parts, then gradually tighten all screws (note: do not tighten excessively).
The wall-mounted cabinet comes with screws and bolts, which is suitable for being mounted on the solid and flat wall surface. Considering the diversity of the wall, you need to purchase the appropriate fittings from a professional dealer. The tools are not supplied.
It is recommended to mount the cabinet by two adults. Pay attention to mount the cabinet horizontally and ensure the firmness to avoid overturning or falling.
Open and close the door lightly, so as not to damage the hinges (opening angle of the door is about 100 degrees).
Please put the article on the flat ground and away from sharp and hard objects. Prohibit rudely dragging the cabinet; please lift it up to finish the move.
For daily care, please clean with a soft and dry cloth. If necessary, you can use a neutral detergent. It is not allowed to wipe the surface with a wet cloth or hard objects.
Keep the article away from acid chemicals, so as not to cause chemical reactions or discoloration, etc.
Keep this product in a room with normal temperature. Avoid direct sunlight or placement next to heat sources, which can cause deformation, distortion, or even cracking.
There may be an odor when unwrapping the packaging; please place the cabinet in a ventilated area and open the door to remove the smell.

Warnings

The product is not intended for children. Children must be under adult supervision to use the product. Otherwise, the seller is not liable for damage or injury.
Never allow children to climb or play around the product, in order to prevent the product from falling and the mirror body from breaking, and to protect children from personal injury.
The wall model must be mounted on the wall with supplied or self-purchased accessories. Prohibit children climbing or hanging on the furniture.
During the mounting process, keep small objects out of the reach of children. It may be fatal if swallowed or inhaled.
To avoid the danger of suffocation, keep the plastic bag away from babies and children.
To prevent potential property damage from the product falling, be sure to secure the product to the wall using the included wall-mounting device prior to use.
Please assess the strength of your wall or ceiling to ensure they can withstand the force of suspending the product.

Assembly Instructions

Tools Required:

A drill, a pencil, a Phillips head screwdriver, and a flat head screwdriver.

Method 1: Hanging on a Door

Attach the hanging brackets (B) to the top of the cabinet (A) using screws (C).
Hang the assembled cabinet onto the door.

Method 2: Wall Mounting

Mark the desired mounting location on the wall with a pencil.
Drill holes at the marked locations. Insert wall anchors (D) into the holes, tapping gently with a hammer if necessary.
Screw the mounting screws (E) into the wall anchors.
Hang the cabinet onto the mounted screws. Ensure the cabinet is level and secure.

Note: The included screws and bolts are suitable for solid, flat walls. For other wall types, please purchase appropriate mounting hardware from a professional dealer.

Product Information

Manufacturer: EUZIEL International GmbH

Version: QM:3.0

Date: 17.05.2023

	Songmics UBBC42 Assembly Manual and Product Information This document provides assembly instructions, parts list, and general guidelines for the Songmics UBBC42 product. It includes detailed steps for assembly, safety warnings, and contact information for customer service.
	SONGMICS Plastic Cube Storage Assembly Instructions Detailed assembly instructions for the SONGMICS Plastic Cube Storage unit (Model LPC905), including parts list, assembly steps, and safety warnings.
	SONGMICS UBCB60 Assembly Manual Assembly instructions and parts list for the SONGMICS UBCB60 storage cabinet. Includes detailed steps and contact information for customer service.
	SONGMICS GKR042 Toy Storage Shelf - Assembly Instructions and Safety Guide Detailed assembly instructions and safety guidelines for the SONGMICS GKR042 Toy Storage Shelf. Learn how to safely build and use this children's storage unit.
	SONGMICS RXJ36 Shoe Rack Assembly Instructions and Guidelines Comprehensive assembly instructions and user guidelines for the SONGMICS RXJ36 Shoe Rack. Features a detailed parts list, step-by-step assembly diagrams described in text, and important usage notes in English.
	SONGMICS GLR040 5-Tier Shelving Unit Assembly Instructions Detailed assembly instructions for the SONGMICS GLR040 5-tier shelving unit. Learn how to safely and correctly assemble your shelving unit with clear steps and important safety guidelines.
	SONGMICS GLR040 Storage Shelving Unit Assembly Instructions A comprehensive guide for assembling the SONGMICS GLR040 storage shelving unit, covering general guidelines, safety precautions, parts identification, and detailed step-by-step assembly instructions.
	SONGMICS Open Wardrobe RYG035 Assembly Instructions Assembly instructions and safety warnings for the SONGMICS Open Wardrobe, model RYG035. Includes parts list and step-by-step assembly guide.