Razor Electric Scooter Brake Caliper Replacement Instructions
Part#: W15128190009
Models: MX500/MX650/SX500/ RSF650/INDIAN YOUTH eFTR
Required Tools (Not Included)
- A. Plier
- B. 5 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Using a pair of pliers, carefully pinch the silver end cap at the end of the brake cable then remove it.
Detailed description of image: A close-up view of the rear wheel area of a Razor electric scooter. A pair of pliers is shown pinching the silver metal end cap of the brake cable. The end cap is circled in white, highlighting the area to be manipulated.
Step 2
Using a 5 mm Allen wrench, loosen the anchor bolt just enough to allow you to pull the brake cable out from the caliper.
Detailed description of image: A close-up view of the brake caliper mechanism on a Razor electric scooter. A 5 mm Allen wrench is inserted into and turning an anchor bolt. The brake cable is visible being pulled away from the caliper. The anchor bolt is circled in white, indicating the adjustment point.
Step 3
Using a 5 mm Allen wrench, loosen the two hex bolts that hold the brake caliper in place and then remove it.
Detailed description of image: A close-up view of the brake caliper assembly mounted to the scooter frame. Two hex bolts securing the caliper are clearly visible and circled in white, indicating they are the fasteners to be loosened for caliper removal.
Step 4
Reverse the Procedures
- Replace brake caliper.
- Re-attach brake cable back into caliper and adjust accordingly.
Attention: Charge battery 12 hours before using.
