EHD DROP STEP

Installation Overview

Estimated Install Time: 60-120 minutes

Requirements: Cutting Not Required, Drilling Not Required

Torque & Tools

Parts List

Verify all parts are present before starting installation.

• Driver/Left Side Front Bracket
• Passenger/Right Side Front Bracket
• Driver/Left Side Center/Rear Bracket (x2)
• Passenger/Right Side Center/Rear Bracket (x2)
• Driver/Left Running Board (marked with "L" on the back)
• Passenger/Right Running Board (marked with "R" on the back)
• Hardware: (12) 8mm x 30mm Hex Bolts, (12) 8mm Flat Washers, (12) 8mm Lock Washers, (12) 8mm x 25mm Combo Bolts

Diagram Description: The diagram illustrates the components, showing the front of the vehicle indicated by an arrow (⬆️). It labels the "L" marking for the Left/Driver Side and "R" marking for the Right/Passenger Side. The parts list includes front and center/rear mounting brackets for both sides, and the running boards themselves.

Before Installation

REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.

Installation Steps

1. Step 1: Prepare Front Mounting Location

   Starting on the Driver/Left front of the vehicle, remove the plastic plugs or factory hex bolts (if equipped) covering the threaded holes in the body panel.

   Diagram Description (Fig 1): Illustrates the driver/left front of the vehicle's body panel, highlighting the threaded holes covered by plastic plugs or hex bolts that need to be removed.

2. Step 2: Attach Driver/Left Front Mounting Bracket

   Select the Driver/Left Front Mounting Bracket. Attach the bracket to the vehicle's front mounting location using (2) 8mm Hex Bolts, (2) 8mm Lock Washers, and (2) 8mm Flat Washers. Do not tighten hardware at this time.

   Diagram Description (Fig 2): Shows the Driver/Left Front Mounting Bracket being secured to the vehicle's front mounting point with the specified hardware (8mm Hex Bolts, Lock Washers, Flat Washers).

3. Step 3: Attach Driver/Left Center and Rear Mounting Brackets

   Move along the body panel to the center and rear mounting locations. Select the remaining (2) Driver/Left Center/Rear Mounting Brackets. Repeat Step 2 to install these brackets on the center and rear mounting locations. Do not tighten hardware.

   Diagram Description (Figs 3 & 4): Depicts the driver/left center and rear mounting locations on the vehicle body panel where the center/rear brackets are to be attached.

4. Step 4: Attach Driver/Left Running Board

   Select the Driver/Left Running Board. NOTE: The Driver/Left Running Board will have a "L" marking beneath the step. Carefully place the Running Board onto the installed brackets. IMPORTANT: Do not slide the Running Board front to back, as this may damage the finish. Attach the Running Board to the (3) Mounting Brackets using (6) 8mm Combo Bolts. Do not tighten hardware.

   Diagram Description (Figs 5 & 6): Shows the Driver/Left Running Board being positioned on the brackets and then secured with (6) 8mm Combo Bolts. Fig 5 shows bracket attachment, Fig 6 shows running board attachment.

5. Step 5: Tighten Hardware

   Level and adjust the Running Board, then fully tighten all hardware.

6. Step 6: Install Passenger/Right Running Board

   Repeat Steps 1–5 to attach the Passenger/Right Running Board. Ensure the board is marked with "R" for the right side.

7. Step 7: Final Inspection

   Do periodic inspections of the installation to ensure that all hardware remains secure and tight.

Attention

To protect your investment, do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Running Boards.