DOMETIC Mini Heki® FL Installation Guide

Product Overview and Components

This guide details the installation of the DOMETIC Mini Heki® FL roof light. The kit typically includes:

• Outer frame (1)
• Inner frame (2)
• Sealing gasket (3)
• Fastening screws (4)

Step 1: Prepare the Opening

1A: Marking: Measure and mark a square opening of 400 mm x 400 mm on the vehicle roof.

1B: Cutting: Cut out the marked opening. Ensure the edges are clean.

1C: Frame Assembly: Insert the inner frame (2) into the outer frame (1).

Step 2: Apply Sealant

2A: Sealant Application: Apply a continuous bead of suitable sealant around the underside of the outer frame (1).

2B: Gasket Placement: Position the sealing gasket (3) onto the outer frame.

Step 3: Install the Unit

3A: Positioning: Carefully place the assembled outer frame unit into the prepared roof opening.

3B: Insertion from Below: From inside the vehicle, insert the inner frame (2) into the outer frame (1).

Step 4: Secure the Unit

4A: Screw Insertion: Insert the fastening screws (4) through the inner frame and into the outer frame.

4B: Tightening: Tighten the screws to a torque of ≤ 1.5 Nm. Ensure the unit is firmly secured and flush with the roof.

Step 5: Seal Edges

5A: Exterior Sealing: Apply sealant around the exterior edges of the outer frame to ensure a watertight seal.

Step 6: Final Interior Assembly

6A: Inner Frame Placement: Insert the inner frame (2) into the outer frame (1) from the interior side.

6B: Securing Inner Frame: The inner frame is typically secured by clips or a locking mechanism.

Step 7: Interior View

7A: Interior Frame: The inner frame features ventilation openings for air circulation.

Step 8: Exterior View

8A: Exterior Frame: The outer frame is designed to be flush with the roof when properly installed.

Step 9: Lid Operation

9A: Lid Mechanism: The roof light lid can be opened and closed using the integrated mechanism.

Step 10: Exterior Lid Open

10A: Exterior View (Open): The outer frame with the lid in the open position.

Step 11: Interior Frame Details

11I: Fly Screen: The inner frame incorporates a fly screen to prevent insects from entering.

11II, III, IV: Fly Screen Operation: These diagrams illustrate the mechanism for operating the fly screen, likely sliding it up or down.

Step 12: Blind Operation

12A: Fly Screen: Shows the fly screen in its position.

12B: Blind: Shows the integrated blind, which can be adjusted to control light and privacy.

Technical Specifications / Dimensions

The following table provides dimensional guidance, potentially related to screw lengths or mounting depths:

Note: Specific dimensions may vary based on the exact model variant or installation context.