GoPro HERO10 Black Bones Quick Start Guide
Getting Started
Step 1: Download the GoPro Quik App
Download the GoPro Quik app from the ? App Store or ▶️ Google Play.
Step 2: Insert SD Card
Insert an SD card into the camera.
Step 3: Connecting to Your Drone
Connect the camera to your drone's flight controller using the GH 1.5 3-pin connector. Ensure correct polarity for Power, Ground, and Shutter wires. Supports Max 5V, 5-27V, and 2S-6S power. Incorrect wiring can permanently damage the camera.
Step 4: Powering On
Power on the camera. The LED will blink 3 times.
Step 5: Pairing with the App
Pair the camera with the GoPro Quik app on your phone by aiming your camera's lens at the QR code displayed on your phone. The LED will blink 2 times to confirm the QR code has been read.
Step 6: Finishing Pairing with the GoPro Quik App
The GoPro Quik app will display 'We Found Your GoPro' and offer options such as 'Pair Camera', 'Upload Footage while Charging', or 'Set up Later'. The app allows you to switch modes, adjust settings, and frame your shot. Ensure your camera is within 1 meter of your phone for pairing. Auto Upload is not supported by HERO10 Black Bones.
LED Status Indicators
LED Status | Description |
---|---|
3 blinks | Camera Power On |
7 blinks | Camera Power Off |
1 blink per 1s | App/Remote Pairing |
2 blinks | QR Code Accepted |
1 blink per 5s | Idle Video Mode |
2 blinks per 5s | Idle Photo Mode |
3 blinks per 5s | Idle Time Lapse Mode |
1 blink per 2s | Recording |
3 blinks | Stop Recording |
Important Information
Use the included mounting fingers to attach your camera to GoPro mounts.
For more information and QR codes, go to gopro.com/bones.
Aim your GoPro camera lens at the QR code to set up your camera with the following settings: Video: 4K60 4:3, Lens: Wide, ISO: Max 1600, HyperSmooth: Off, Color: Flat, EV Comp: -0.5, Bit Rate: High, Sharpness: Medium.
⚠️ WARNING: HERO10 Black Bones is not waterproof.
For best performance, ensure there is enough airflow around your camera.