Onn. Wireless Earphones Quick Start Guide
Model: 100024715
The Fine Print
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help? We're here for you every day from 7 a.m. - 9 p.m. CST. Give us a call at 1-888-516-2630.
Produced for Walmart Inc., Bentonville, AR 72716
Ver.01 01/01/20
FCC ID: 2ALVK--ONN24715
Get to Know Your Wireless Earbuds
- Model: 100024715
- Speaker Diameter: 7mm
- Speaker Impedance: 32Ω±10%
- Sensitivity: 109±3dB at 1KHz
- Speaker Driver Rating Power: 3mW
- Charging Cable: 25cm
- 24 hours of total playtime at normal mode (with charging case)
- IPX5 waterproof rating applies to the earphones, not to the charging case.
What's in the Box?
Check to make sure you have everything below:
- 1. Earphones x1 pair
- 2. Charging case x1
- 3. Eartips x5 pairs (memory foam ear tips installed)
- 4. USB-C charging cable x1
- 5. Quick Start Guide x1
Diagram Description: The diagram displays the package contents: a pair of Onn. wireless earbuds, a charging case, five pairs of ear tips in various sizes (Small, Medium, Large, Extra Large), a USB-C charging cable, and the Quick Start Guide booklet.
Let's Get Started! First Time Setup
Step 1: Place earphones into charging case for initial activation and close the lid to fully charge.
Diagram Description: Shows a pair of wireless earbuds being placed into their charging case.
Step 2: Open the charging case lid; pairing mode is automatically initiated.
Diagram Description: Shows the charging case lid open, with a Bluetooth icon indicating that the earbuds are now in pairing mode.
Step 3: Connect to your device through Bluetooth wireless technology. Search for the entry "onn. True Wireless ANC" on your device.
Diagram Description: Shows a smartphone screen displaying a list of available Bluetooth devices, with "onn. True Wireless ANC" highlighted as the device to connect to.
Power On/ Power Off & Pairing
Automatic Power On/Connect: Open the charging case lid; earphones will power on automatically and connect to the last paired device.
Diagram Description: Shows the charging case open with the earbuds inside, indicating they will automatically power on and connect to the last paired device.
Automatic Power Off/Disconnect: Place earphones back into the charging case and close the lid; earphones will power off automatically and disconnect.
Diagram Description: Shows the earbuds being placed back into the charging case and the lid closing, indicating they will automatically power off and disconnect.
Manual Power On/Off: Press & Hold for 5 seconds. (If you are carrying the earphones without the charging case).
Diagram Description: Shows a finger pressing and holding an earbud for approximately 5 seconds, indicating manual power on/off.
Pairing with a New Device: If you want to pair with another device, please turn off Bluetooth from your last paired device if it is nearby, then open the charging case cover for pairing. It takes about 6-8 seconds to search for another device.
Diagram Description: Illustrates turning off Bluetooth on a previously connected device, then opening the charging case to initiate pairing with a new device.
Enjoy your music & Take a Clear Phone Call
Music Controls:
- Play/Pause: Single press (x1) on either earbud.
- Next Track: Double press (x2) on either earbud.
- Previous Track: Triple press (x3) on either earbud.
Phone Call Controls:
- Answer/Hangup Call: Single press (x1) on either earbud.
- Reject Incoming Call: Double press (x2) on either earbud.
Special Modes:
- Noise Canceling / Ambient Mode: Press and hold (for 1 sec) on either earbud.
- Voice Assistant (Siri / Google Assistant): Single press + Press and hold (x1 Press + Press & Hold) on either earbud.
Note: During an active phone call, Ambient Mode cannot be activated.
Diagram Description: Diagrams illustrate the touch controls on the earbuds: Single press (x1) on an earbud: Play/Pause music or Answer/Hangup a call. Double press (x2) on an earbud: Skip to the Next Track or Reject an incoming call. Triple press (x3) on an earbud: Go to the Previous Track. Press and hold for 1 second: Toggle between Noise Canceling and Ambient Mode. Single press followed by a press and hold: Activate Siri or Google Assistant.
Charge Your Earphones
Earphones Charging:
The left or right earphone's LED light will blink white while charging. After 10 seconds, the LED light will turn off, but the earphone is still charging until fully charged.
Diagram Description: Shows the earbuds inside the charging case. The LED lights on the earbuds blink white during charging and turn off once fully charged.
Case Charging:
- Via USB-C Cable: Approximately 2.5 hours to fully charge.
- Via Wireless Charging Pad (Not Included): Approximately 4.5 hours to fully charge.
When the charging case is fully charged, 3 LED indicator lights will be illuminated.
Diagram Description: Shows the charging case being connected via a USB-C cable for charging, and also placed on a wireless charging pad. It indicates that when the case is fully charged, all three LED indicator lights will be illuminated.
Manufacturing & Printing Specifications
Product Name: QSG Manual (QSG说明书)
Issue Date: 2020-10-20
Part Number: [Not Specified]
Version: v1
Requirements:
- Size: 571x108mm
- Craft: 157g coated paper, two-color + single black printing, accordion fold.
- Color Options: [Visual swatches shown in original document, not reproducible here as text]
- 1. Material weight is sufficient.
- 2. Surface scratch area is less than 0.5% of the total area.
- 3. Printing color difference is less than 10%.
- 4. Folding is aligned and flat.
- 5. Unfolded positive/negative tolerance is less than 1mm; folded positive/negative tolerance is less than 1mm.
Support
For assistance, please contact Walmart customer support at 1-888-516-2630. Support is available daily from 7 a.m. to 9 p.m. CST.