Tow-Trust TC713H Towbar Fitting Instructions
For Fiat Fullback (2016>) and Mitsubishi L200 (2006> Inc. SERIES 5 & 6)
Parts Included
| Item | Qty | Description | Item | Qty | Description |
|---|---|---|---|---|---|
| A | 1 | TC713H Crossmember | G | 2 | M16 x 55 Bolts & Nyloc Nuts |
| B | 2 | Side Arms | H | 12 | M12 x 40 Bolts, 8 Nyloc Nuts & 4 S/P Washers |
| C | 2 | Angle Brackets | J | 2 | M12 x 35 Bolts & Nyloc Nuts |
| D | 2 | Chassis Adaptors | K | 4 | M14 x 45 Bolts, Nyloc Nuts & 2 S/P Washers |
| E | 1 | Slider Face Plate | L | 24 | 12 x 25 Flat Washers |
| E1 | 2 | Slider Pins (205) & Clips | M | 8 | 14 x 27 Flat Washers |
| F | 4 | M12 Clamp Plates |
Fitting Instructions
- Remove the two fixings either side securing the under run bar. Discard bar and fixings.
- Using Item H with Item L fix Items B to each chassis member using Item F at the forward most mounting point. (Club Cab & Series 6 models will also require Item D to be fitted at this stage, see image below).
- Locate Item F inside each chassis member and line up with the vertical mounting point (Series 6 doesn't use Item F), using Item H with Item L fix Items C to Items B and the vertical mounting point. (Club Cab & Series 6 models also require Item J and Item L to fix Item B and Item D together).
- Using Item K with Item M fix Item A between each side arm.
- Using Item G fix your desired ball bracket (not supplied in this kit) to Item E.
- Fully tighten all fixings ensuring the Towbar is rigid, square and secure.
Assembly Diagram Description
The main diagram illustrates the towbar assembly, showing the crossmember (A) connecting to the vehicle chassis via side arms (B) and angle brackets (C). Various components are labeled with letters corresponding to the parts list. The diagram also details specific mounting configurations for different vehicle cab types:
- SINGLE / DOUBLE CAB: Shows the general mounting points for the towbar assembly.
- CLUB CAB: Illustrates specific mounting points, potentially indicating variations in chassis structure or required components.
- SERIES 6 ONLY: Highlights mounting points and components specific to Series 6 models, noting that Item F might not be used in this configuration.
A detail view shows a 'LINCH PIN' and 'R CLIP', which are used for securing the towball mount.
Important Notes
- Recommended Torque Setting for M12 Grade 10.9: 130 Nm. (For other Torque Settings see notes overleaf.)
- Nose load limits and vehicle manufacturers trailer / caravan weight limits must be observed.
