AstroAI 250 PSI Tire Inflator Gauge
Thank you for purchasing the AstroAI 250 PSI Tire Inflator Gauge. Inflate tires without having to continually check pressure and then adjust. We hope you enjoy your new Tire Inflator Gauge.
Inflator Gauge Diagram
The diagram illustrates the AstroAI 250 PSI Tire Inflator Gauge and its components. It shows a central digital display unit connected to a hose, with various control buttons and connectors. The numbered parts are:
- 1. Valve Controller
- 2. Air Bleed Valve/Reset Button
- 3. NPT Male End
- 4. NPT Threaded Female Connector
- 5. Interchangeable Brass Chucks
- 6. 18" Rubber Hose
- 7. Digital Gauge Display
- 8. Battery Compartment
Instructions
Inflate Tires Using an Air Compressor
- Thread one of the NPT connectors to the bottom of the tire gauge.
- Connect the AstroAI Inflator Gauge to an air compressor using the NPT connector.
- Press the Air Bleed Valve/Reset Button to ensure the gauge is set to Zero.
- Connect an Air Chuck to the rubber hose. Use the chuck to connect to the tire valve.
- Fill by pressing the Valve Controller to desired pressure level.
- Release excess air using the Air Bleed Valve/Reset Button.
Specifications
- Inflation Range: 0-250 PSI
- Accuracy: ±1%
- Display Resolution: 0.1 PSI
- Display Type: Backlit LCD
- Measurement Units: PSI, KPA, Bar, Kg/cm2
- Compatibility: NPT air compressor connector
Package Contents
- 1 x AstroAI Tire Inflator Gauge
- 1 x User Manual
- 4 x Valve Caps
- 1 x Twist-on Air Chuck
- 1 x Brass Air Chuck
- 2 x AAA Batteries
- 1 x 1¼" NPT Steel Fitting
- 1 x Valve core tool
- 1 x Thread Seal Tape Roll
- 1 x Twist-on Air Chuck