Guangzhou Chicken Run Network Technology Co.,Ltd. G7PRO Game Controller 2AF9S-G7PRO 2AF9SG7PRO g7pro
MAXLAB Testing Co.,Ltd. Report No.: MAX25052912P01-R01RF RF TEST REPORT Report Reference No........................ : FCC ID................................................. : Compiled by ( position+printed name+signature).. : Supervised by ( position+printed name+signature).. : Approved by ( position+printed name+signature).. : Date of issue.........................................: MAX25052912P01-R01RF 2AF9S-G7PRO Engineer/ Cindy Zheng Manager/Haley Wen RF Manager/ Vivian Jiang June 6, 2025 Testing Laboratory Name................ : MAXLAB Testing Co.,Ltd. 1/F, Building B, Xinshidai GR Park,Shiyan Street, Bao'an District, Address................................................. : Shenzhen,Guangdong, 518052, People's Republic of China Applicant's name............................... : Guangzhou Chicken Run Network Technology Co.,Ltd. Address................................................. : Test specification.............................. : Room 1001&1003, No. 19, Yard 2, Yuancun West Street, Tianhe District, Guangzhou, China Standard................................................ : FCC 1.1310 KDB 447498 D01 General RF Exposure Guidance v06 MAXLAB Testing Co.,Ltd. All rights reserved. This publication may be reproduced in whole or in part for non-commercial purposes as long as the MAXLAB Testing Co.,Ltd. is acknowledged as copyright owner and source of the material. MAXLAB Testing Co.,Ltd. takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Test item description........................: Game Controller Trade Mark............................................: GameSir Manufacturer.........................................: GuangZhou Chicken Run Network Technology Co.,Ltd. Model/Type reference......................... : GameSir-G7 Pro Listed Models ...................................... : N/A Modulation ........................................... : GFSK, /4DQPSK, 8DPSK Frequency.............................................. From 2402MHz to 2480MHz Rating.....................................................: DC 3.7V From Battery and DC 5V From External circuit Result.....................................................: PASS - Page 1 of 4 - MAXLAB Testing Co.,Ltd. Report No.: MAX25052912P01-R01RF RF EXPOSURE EVALUATION METHOD According to FCC 1.1310: The criteria listed in the following table shall be used to evaluate the environment impact of human exposure to radio frequency(RF) Radiation as specified in §1.1307(b) According to KDB 447498 D01 General RF Exposure Guidance v06, Unless specifically required by the published RF exposure KDB procedures, standalone 1-g head or body and 10-g extremity SAR evaluation for general population exposure conditions, by measurement or numerical simulation, is not required when the corresponding SAR Test Exclusion Threshold condition(s), listed below, is (are) satisfied. EUT Specification EUT Frequency band (Operating) Device category Exposure classification Antenna diversity Max. output power Antenna gain (Max) Evaluation applied Game Controller WLAN: 2.412GHz ~ 2.462GHz WLAN: 5.150GHz ~ 5.250GHz WLAN: 5.725GHz ~ 5.850GHz Others BT:2402-2480MHz Portable (<20cm separation) Mobile (>20cm separation) Others Occupational/Controlled exposure (S = 5mW/cm2) General Population/Uncontrolled exposure (S=1mW/cm2) Single antenna Multiple antennas Tx diversity Rx diversity Tx/Rx diversity -2.341dBm (0.00058W) 1.81 dBi MPE Evaluation SAR Evaluation - Page 2 of 4 - MAXLAB Testing Co.,Ltd. Report No.: MAX25052912P01-R01RF RF EXPOSURE EVALUATION METHOD SAR Test Exclusion Thresholds for 100 MHz 6 GHz and 50 mm Approximate SAR Test Exclusion Power Thresholds at Selected Frequencies and Test Separation Distances are illustrated in the following Table. The 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] · [f(GHz)] 3.0 for 1-g SAR and 7.5 for 10-g extremity SAR,where f(GHz) is the RF channel transmit frequency in GHz Power and distance are rounded to the nearest mW and mm before calculation The result is rounded to one decimal place for comparison The test exclusions are applicable only when the minimum test separation distance is 50 mm and for transmission frequencies between 100 MHz and 6 GHz. When the minimum test separation distance is < 5 mm, a distance of 5 mm is applied to determine SAR test exclusion. - Page 3 of 4 - MAXLAB Testing Co.,Ltd. Report No.: MAX25052912P01-R01RF Maximum measured transmitter power. BR+EDR+BLE Operating Mode Measure Frequency d Power (MHz) (dBm) max. power (mW) Antenna Gain min. test separation distance (dBi) (mm) Result Limit 2402 -5.061 0.31 1.81 5 0.0967 3 GFSK 2441 -4.239 0.38 1.81 5 0.1177 3 2480 -4.295 0.37 1.81 5 0.1172 3 2402 -4.456 0.36 1.81 5 0.1111 3 /4DQPSK 2441 -3.666 0.43 1.81 5 0.1343 3 2480 -3.653 0.43 1.81 5 0.1358 3 2402 -3.960 0.40 1.81 5 0.1245 3 8DPSK 2441 -3.367 0.46 1.81 5 0.1439 3 2480 -3.320 0.47 1.81 5 0.1466 3 2402 -2.341 0.58 1.81 5 0.1808 3 GFSK 2440 -2.652 0.54 1.81 5 0.1696 3 2480 -2.854 0.52 1.81 5 0.1633 3 The 1-g and 10-g SAR test exclusion thresholds for 100 MHz to 6 GHz at test separation distances 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance,mm)] · [f(GHz)] The test Result is less than 3.0 for 1-g SAR and 7.5 for 10-g extremity SAR. Conclusion: No SAR is required. - Page 4 of 4 -