V-TAC INNOVATIVE LED LIGHTING

Technical Data

3️⃣ YEAR WARRANTY

Installation Diagram

The installation process is illustrated in 12 steps:

1. Step 1: Shows power switch in 'OFF' position.
2. Step 2: Illustrates drilling holes in a wall.
3. Step 3: Depicts inserting a plastic anchor into a drilled hole.
4. Step 4: Shows fixing a wall plate onto the wall.
5. Step 5: Illustrates connecting wires to terminals.
6. Step 6: Shows a screwdriver and screws for mounting.
7. Step 7: Depicts connecting wires with terminal blocks.
8. Step 8: Shows the wall plate mounted and wires connected.
9. Step 9: Illustrates attaching the lamp body to the wall plate.
10. Step 10: Shows the assembled lamp on the wall.
11. Step 11: Depicts installing a bulb into the lampholder.
12. Step 12: Shows the final lamp with power switch in 'ON' position.

Introduction & Warranty

Thank you for selecting and buying a V-TAC product. V-TAC aims to provide excellent service. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. For any queries, please contact your dealer or local vendor, who are trained to assist you.

The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. V-TAC provides no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 hours of daily operation. Usage of the product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.

Warnings

• Ensure electricity is switched OFF before installation. [power-off symbol]
• Please read through all following instructions before installing the unit.
• Users should prepare necessary accessories and spare parts (not provided).

Installation Instructions

1. Turn off the power.
2. Drill the holes in the wall.
3. Insert the plastic wall plugs into the holes.
4. Fix the wall plate onto the wall.
5. Connect supply leads: terminal brown (L) to brown wire, blue (N) to blue wire, and greenish-yellow [earth symbol] to greenish-yellow wire.
6. Install the bulb into the lampholder.
7. Tighten the nuts to fix down the lamp.
8. Turn on the Power.