Instruction Manual for COMMAND ACCESS models including: DL20, Door Loops, Door, Loops

DoorLoop20Diagram CAT

Installation Instructions

Command Access - Power Transfer Door Loop - 20" Length - Optional Finish – UHS Hardware

Current View
Command-Access-DL20-Door-Loop-is ?v=1646320283
Mounting Instructions For "DL20" Door Loops

THIS DIAGRAM APPLIES TO all DL Series Door Loops

1- Locate the centerline of the door loop on the underside of the Exit Device Housing 4" from soffit of frame and 1" from face of door
2- Locate the centerline of the door loop for the face of frame 2" down from the edge of the Exit Device 3- Drill pilot holes (#24 drill) to mount the base and a 5/8" hole for wire conduit. 4- Mount base using #10 SMS. 5- Thread electrical wires through door loop. 6- Install covers with #8 SMS screws
NOTES: Maximum electrical wires: 7 ea. 18 awg, 10 ea. 22 awg Door Loop flexible conduit can be field cut

Rim Exit Device
4"
DL-20 Door Loop
Door Loop Base Dimensions
.625 2.013
.732 .200
.732
.250 2.379

2"
Alternate wall Placement. Check loop slack.
Door Frame Face


Adobe Illustrator CS4 Adobe PDF library 9.00