Product Liability Disclaimer-MEAN WELL Switching Power Supply ManufacturerGlobal Trade Item Number (GTIN)-MEAN WELL Switching Power Supply Manufacturer
Owner's Manual for MEAN WELL models including: APV-16-5, APV-16-12, APV-16-15, APV-16-24, APV-16 Series Single Output Switching Power Supply, APV-16 Series, Single Output Switching Power Supply, Output Switching Power Supply, Switching Power Supply, Power Supply, Supply
MEAN-WELL USA, INC. - РКС Компоненти - РАДІОМАГ
File Info : application/pdf, 2 Pages, 527.34KB
DocumentDocument16W Single Output Switching Power Supply APV-16 series SPECIFICATION User's Manual LPS IP42 IS 15885(Part 2/Sec13) THOMAS SAMUEL THOMAS SAMUEL R-41027766 MODEL APV-16-5 APV-16-12 APV-16-15 APV-16-24 OUTPUT DC VOLTAGE 5V 12V 15V RATED CURRENT 2.6A 1.25A 1A CURRENT RANGE 0 ~ 2.6A 0 ~ 1.25A 0 ~ 1A RATED POWER 13W 15W 15W RIPPLE & NOISE (max.) Note.2 100mVp-p 120mVp-p 120mVp-p VOLTAGE TOLERANCE Note.3 ±5.0% LINE REGULATION ±1.0% LOAD REGULATION ±2.0% SETUP, RISE TIME Note.6 1500ms, 30ms / 230VAC 1500ms,30ms / 115VAC at full load HOLD UP TIME (Typ.) 20ms/230VAC 12ms/115VAC at full load 24V 0.67A 0 ~ 0.67A 16.08W 150mVp-p VOLTAGE RANGE Note.4 90 ~ 264VAC 127 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz INPUT EFFICIENCY (Typ.) 76% 80% 81% 83% AC CURRENT 0.3A/230VAC 0.5A/115VAC INRUSH CURRENT(Typ.) COLD START 50A(twidth=250s measured at 50% Ipeak) at 230VAC MAX. No. of PSUs on 16A CIRCUIT BREAKER 13 units (circuit breaker of type B) / 22 units (circuit breaker of type C) at 230VAC LEAKAGE CURRENT 0.25mA / 240VAC OVER LOAD PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16V 17.5 ~ 21V Protection type : Shut off o/p voltage, clamping by zener diode -30 ~ +70(Refer to "Derating Curve") 20 ~ 90% RH non-condensing -40 ~ +80, 10 ~ 95% RH ±0.03%/ (0 ~ 50) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes 27.6 ~ 32.4V SAFETY STANDARDS Note.8 UL8750,CSA C22.2 No.250.0-08, BIS IS15885(except for 15V),EAC TP TC 004,IP42 , BS EN/EN 62368-1 approved SAFETY & WITHSTAND VOLTAGE EMC ISOLATION RESISTANCE EMC EMISSION I/P-O/P:3.75KVAC I/P-O/P:>100M Ohms / 500VDC / 25/ 70% RH Compliance to BS EN/EN55032,BS EN/EN61000-3-2,BS EN/EN61000-3-3, EAC TP TC 020 EMC IMMUNITY Compliance to BS EN/EN55035,BS EN/EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), EAC TP TC 020 MTBF 7265.5K hrs min. Telcordia SR-332 (Bellcore) ; 1128.9K hrs min. MIL-HDBK-217F (25) OTHERS DIMENSION 77*40*29mm (L*W*H) PACKING 0.1Kg; 120pcs/14Kg/1.06CUFT NOTE 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. Please connect L line to the positive pole and N line to the negative pole under DC input. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. (as available on https://www.meanwell.com//Upload/PDF/EMI_statement_en.pdf) 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. This product is not intended for LED lighting luminaire applications in the EU and China.(In the EU and China the LPF/NPF/XLG/XLC/XLN series are recommended.) 8. The ambient temperature derating of 3.5/1000m with fanless models and of 5/1000m with fan models for operating altitude higher than 2000m(6500ft). 9. Products sourced from the Americas regions may not have the ENEC/BIS logo. Please contact your MEAN WELL sales for more information. 10. For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf Downloaded from Arrow.coPmro. duct Liability DisclaimerFor detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx File Name:APV-16-SPEC 2024-10-16 16W Single Output Switching Power Supply Mechanical Specification 90 82.5 77 AC/N(Blue) AC/L(Brown) UL1569 18AWG 150±10 31 T case T case: Max. Case Temperature APV-16 series Unit:mm Tolerance:±1 150±10 UL1569 20AWG +V(Red) -V(Black) 40 15.5 19 29 Block Diagram I/P EMI FILTER RECTIFIERS POWER SWITCH- ING PWM CONTROL RECTIFIERS & FILTER DETECTION CIRCUIT fosc : 67KHz +V -V Derating Curve Static Characteristics 100 80 60 50 40 20 -30 0 10 20 30 40 50 60 70 (HORIZONTAL) AMBIENT TEMPERATURE () 100 90 80 70 60 50 40 90 100 200 210 220 230 240 250 264 INPUT VOLTAGE (VAC) 60Hz LOAD (%) LOAD (%) Downloaded from Arrow.com. File Name:APV-16-SPEC 2024-10-16