The rear panel and side panels are attached with six phillips screws #2. Screw them out.. DeLonghi ESAM 3000.B Magnifica Open. Draft: 2023-01-31.
DeLonghi ESAM 3000.B Magnifica Open Guide ID: 98952 - Draft: 2021-01-29 DeLonghi ESAM 3000.B Magnifica Open Opening a DeLonghi Esam 3000.B (Magnifica) coffee machine Written By: VauWeh This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 1 of 6 DeLonghi ESAM 3000.B Magnifica Open TOOLS: Kreuzschlitzschraubendreher PH 2 (1) Guide ID: 98952 - Draft: 2021-01-29 This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 2 of 6 DeLonghi ESAM 3000.B Magnifica Open Guide ID: 98952 - Draft: 2021-01-29 Step 1 -- DeLonghi ESAM 3000.B Magnifica Open Pull the plug! Remove the drip tray, the water tank and the pulp container. Step 2 The back panel and side panels are attached with six phillips screws PH2. Screw it out. This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 3 of 6 DeLonghi ESAM 3000.B Magnifica Open Step 3 Guide ID: 98952 - Draft: 2021-01-29 Slide the right side panel about 2 cm to the back. Then solve it. Step 4 The left side is a bit stuck. Place a plastic opening tool in the gap between the front and left side panel above the opening for the water tank. Lift the gap slightly larger. Then place the tool in the gap between the front and left side panel under the opening for the water tank. Increase the gap and push the side part about 2 cm to the rear. Lift out the left side piece. This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 4 of 6 DeLonghi ESAM 3000.B Magnifica Open Step 5 Guide ID: 98952 - Draft: 2021-01-29 Take out the back Step 6 The front panel is secured with four PH2 Phillips screws, two left and one right each. Turn it out. Use a plastic opening tool to lever off the steam tap. Carefully pull the front panel about 1 cm forward so that there is a gap between the top cover and the front panel, Do not pull the front panel too far, it is still attached with different hoses and cables. This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 5 of 6 DeLonghi ESAM 3000.B Magnifica Open Step 7 Guide ID: 98952 - Draft: 2021-01-29 Two Phillips screws PH2 hold the lid at the back. Turn it out. Lift the lid upwards. Repeat the steps in order to reassemble your device. This document was generated on 2021-02-09 12:10:10 AM (MST). © iFixit -- CC BY-NC-SA www.iFixit.com Page 6 of 6wkhtmltopdf 0.12.5 Qt 4.8.7