VeriFone 660 Certifications and Regulations

FCC/ISED Compliance

General Information

Manufacturer: VeriFone, Inc.

Brand: Verifone

Model: V660p-A, V660p Plus-A

Part 15 of FCC and ISED Rules

This device complies with the limits for a Class B digital device as specified in Part 15 of FCC and Innovation, Science and Economic Development Canada license-exempt RSS standard(s) Rules, providing reasonable protection against harmful interference in a residential installation. Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

This equipment generates and uses radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. In the event of interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or ask an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. The use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC Rules.

Any changes or modifications to this equipment not expressly approved by Verifone could void the user's authority to operate this equipment.

Note: The country code selection is for non-US models only and is not available to all US models. Per FCC regulation, all Wi-Fi product markets in the US must be fixed to US operation channels only.

Le présent appareil est conforme aux CNR d'Innovation, Science and Economic Development Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage. (2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées. La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux États-Unis et au USA/Canada.

This Class B digital apparatus complies with CAN ICES(B). Cet appareil numérique de la classe B est conforme à la norme NMB(B) du Canada.

RF Exposure

CE

This device complies with the Radio Equipment Directive (2014/53/EU). A minimum separation distance of 0.5 cm must be maintained between the device and the user's body during body-worn operation, and a minimum separation distance of 0 cm must be maintained between the device and the user's extremity during extremity operation to comply with RF exposure requirements in Europe. To comply with RF Exposure requirements in Europe, third-party belt clips, holsters, or similar accessories used by this device should not contain any metallic components. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements and should be avoided.

USA

The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such a function is available.

The SAR limit set by the FCC is 1.6W/kg for body-worn SAR and 4W/kg for extremity SAR. This device complies with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and has been tested in accordance with the measurement methods and procedures specified in IEEE 1528-2013. This device has been tested and meets the FCC RF exposure guidelines by being positioned a minimum of 0.5 cm from the body.

ISED

This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and has been tested in accordance with the measurement methods and procedures specified in IEEE 1528 and IEC 62209. This equipment should be installed and operated with a minimum distance of 0.5 cm between the radiator and your body. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Cet appareil est conforme aux limites d'exposition DAS incontrôlée pour la population générale de la norme CNR-102 d'Industrie Canada et a été testé en conformité avec les méthodes de mesure et procédures spécifiées dans IEEE 1528 et IEC 62209. Cet appareil doit être installé et utilisé avec une distance minimale de 0.5 cm entre l'émetteur et votre corps. Cet appareil et sa ou ses antennes ne doivent pas être co-localisés ou fonctionner en conjonction avec tout autre antenne ou transmetteur.

Electrical

Power Source

Before connecting the terminal power pack to an electrical outlet, check that the power switch on the terminal is off. If the terminal does not have an on/off switch, check that the power cable connector is removed from the terminal's power port. When connecting the terminal to a power pack, always connect the plug of the power pack to an electrical wall outlet first, then connect the power cable to the terminal's power port.

The reference input power rating is as follows:

• Input Voltage: 100-240V AC, 50/60 Hz
• Output Voltage: 5V DC, 2.2A

Models V660p-A and V660p Plus-A are intended to be provided with a UL listed power supply module having an output rating of 5V DC, minimum 2.2A, Tma 45°C, Class II, DPIU type and evaluated as a Limited Power Source or PS2 or equivalent.

AC Adapter

The AC adapter is designed to ensure your safety and compatibility with this equipment. Please follow these guidelines:

• Do not use the adapter in a high-moisture environment. Never touch the adapter when your hands or feet are wet.
• Allow adequate ventilation around the adapter. Avoid locations with restricted airflow.
• Connect the adapter to a proper power source. The voltage and grounding requirements are found on the product case and/or packaging.
• Do not use the adapter if the cord is damaged.
• Do not attempt to service the adapter. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture.

Disconnecting Power

Disconnecting power during a transaction may cause transaction data files that are not yet stored in the terminal memory to be lost.

Equipment

Location - Electrical Considerations

CAUTION

This device contains sensitive electronic components that can be permanently damaged if exposed to excessive shock, electrical interference, or vibration.

Due to the risk of electric shock or damage to the terminal, do not use this equipment near a water source (e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool). Likewise, avoid using this product during thunderstorms causing power cuts. Avoid placing the terminal near electrical devices or other units that could cause large voltage fluctuations or electrical interference, such as air conditioners, neon signs, high-frequency safety devices, or electrical equipment.

Damage

Carefully inspect the shipping carton and its contents for any damage. If the unit or any product component appears damaged or to have been tampered with, immediately notify the shipping company and your Verifone distributor or service provider. Do not use V660p-A and V660p Plus-A units that have been tampered.

Repairs

Do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local Verifone distributor or service provider for assistance. Failure to comply may void the product warranty.

Location - Environmental Considerations

Do not plug the power pack into an outdoor outlet. Any damage to the unit from exposure to water or dust may void your warranty. Do not use the terminal where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the terminal away from direct sunlight and anything that radiates heat, such as a stove or a motor.

WARNING

Your POS terminal contains sensitive electronic components that can be permanently damaged if exposed to excessive shock or vibration. To minimize the risk of damage to your terminal, avoid dropping your terminal and operating it in high-shock and high-vibration environments. Do not store the terminal where prolonged exposure to extreme temperatures can occur, as it can cause permanent damage. Do not expose the terminal to water. Contact with water can cause this unit to malfunction.

Cleaners and Solvents

Never use thinner, trichloroethylene, or ketone-based solvents to clean the V660p-A and V660p Plus-A devices, as these may deteriorate plastic or rubber parts. Do not spray cleaners or other solutions directly onto the keypad or display. For best results, use a clean cloth dampened with water and mild soap. To remove stubborn stains, use alcohol or an alcohol-based cleaner.

Notice for WLAN

CE WLAN: 5250-5350 MHz. This device is restricted for indoor usage only when operating in the 5250 to 5350 MHz frequency range.

UK WLAN: 5250-5350 MHz. This device is restricted for indoor usage in the UK when operating in the 5250 to 5350 MHz frequency range.

ISED WLAN: 5150-5250 MHz. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.

Where applicable, antenna type(s), antenna model(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.

Supported Country Codes for WLAN

This equipment may be operated in:

Notice for Operating Frequency and Output Power

Operating Temperature

The product is designed to work at maximum ambient temperatures of (Tma) 0°C and 45°C.

Battery Pack Protection Temperature Warning Statement

• The highest specified charging temperature of the battery pack is 45±2°C.
• The lowest specified charging temperature of the battery pack is 0±2°C.

Battery Pack/Coin Cell Instructions for Portable Product

Dispose of the battery/coin cell in accordance with all national, state, and local laws and regulations as regionally required. Some batteries may be recycled and may be accepted for disposal at local recycling centers.

CAUTION

There is a risk of explosion if the battery is replaced by an incorrect type.

Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, can result in an explosion. Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas. A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

Recycling Information

DO NOT DISCARD! UNIT MUST BE RECYCLED OR DISPOSED OF PROPERLY.

For proper disposal instructions, go to http://recycle.verifone.com/

Recyclage: NE PAS JETER! L'unité doit être recyclée ou mise au rebut dans les endroits prévus à cet effet. Pour connaître les procédures de mise au rebut, consultez le site http://recycle.verifone.com/