Philips Dynalite DDBC300-D DALI Driver Controller

Safety and Installation Requirements

Warning: Installation must be performed by a qualified electrician in an approved enclosure, adhering to all national and local electrical and construction codes and regulations.

IEC Pollution Degree II

IEC Overvoltage Category III

Product Specifications and Dimensions

Product: Philips Dynalite DDBC300-D DALI Driver Controller

Physical Dimensions:

• Width: 94 mm (3.70 in)
• Length: 211 mm (8.31 in)
• Depth: 75 mm (2.95 in)
• Mounting Hole Spacing: 45 mm (1.77 in)

Environmental Limits:

• Operating Temperature: 0°C to 40°C (32°F to 104°F) ?️
• Maximum Humidity: ≤90% ?

DALI Control Channel Ratings:

• Addressing: Addressable
• Channels per Device: ≤ 64
• Total Addressable Devices: < 192
• Guaranteed Current: 128 mA
• Maximum Current: 250 mA
• Insulation: Basic

Electrical Connections

Power Input

100-240 V~ 0.5 A

DALI Connections

Terminals for DALI 1, DALI 2, DALI 3 (DA-, DA+ pairs). Unused DALI loops should be marked "NOT CONNECTED LOOP".

Wire Gauge: ≤5.5 mm² / 10+ AWG for main DALI, ≤2.5 mm² / 12+ AWG for other DALI/DyNet.

Torque: 0.6 Nm (5.5 Lb-in) for main DALI, 0.5 Nm (4.4 Lb-in) for other DALI/DyNet.

DyNet/RS-485 Communication

Connections: SHLD, GND, D+, D-, +12V, AUX/UL924.

+12V and AUX/UL924 are SELV/Class 2 (UL) rated.

Maximum cable length for AUX/UL924 and RS-485 DyNet: < 20 m.

Wire Gauge: ≤2.5 mm² / 12+ AWG.

Torque: 0.5 Nm (4.4 Lb-in).

Other

RJ12 connector.

Important Notes

Note: This is a Class A product. In a domestic environment, it may cause radio interference; users may need to take corrective measures.

Installation must comply with IEC 60364 (all parts). Ensure communication wire temperature limits and current-carrying capacities per IEC 60364-5-52 are not exceeded.