GOTRAX GKS KIDS ELECTRIC SCOOTER

Congratulations On Your Purchase!

This user manual will help you assemble and operate your new electric scooter. Be sure to read ALL OF THE INFORMATION in this manual before riding.

NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE: It's very important that you get parental permission before riding your electric scooter.

Don't Ride Until You Read This:

• ⛑️ ALWAYS wear a helmet when riding your electric scooter.
• ? Make sure your scooter has a full battery before taking it out to ride.
• ⚠️ Always be aware of local road laws, and follow them.
• ? Do not ride the scooter under the influence of drugs or alcohol.
• ? Always respect pedestrians.
• ?️ Do not ride under wet conditions. The scooter may slide from under your feet causing injury. Wet conditions may damage the electronics and void the warranty.

Warning Message

1. Avoid water: The scooter is not waterproof. The electronics may be damaged due to water, and water damage is not covered by the warranty. Riding in wet conditions is also very dangerous and may result in injury.
2. Abuse: Physical damage due to negligent care and extreme riding is not covered.
3. Whenever you ride the Gotrax scooter, you risk severe injury or even death from loss of control, collisions, and falls. Use caution and ride at your own risk.
4. Do not modify the product from the manufacturer's original design.
5. Keep hands and all body parts away from moving parts while operating the scooter.
6. Before riding: Be sure to check the scooter over and make sure it is operating correctly before each use.
7. Before riding: Be sure that the braking system is functioning properly; also be sure that all safety labels are in place and you understand the safety warnings.
8. Before riding: Be sure that any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition.
9. Before riding: Be sure to check that the tires are in good condition, inflated properly, and have sufficient tread remaining.
10. Never exceed the 121 lb (55 kg) maximum load rating.
11. The electric scooter should never be used by children under the age of 8.
12. Maximum Speed: Your electric scooter has a maximum speed of 7.5 mph.

Unpack

You should find each of these items in your box:

• 1. Scooter Front & Rear Wheel Compartment
• 2. Tiller & Handlebars
• 3. Approved Power Adapter / Charging Unit
• 4. 4 mm Allen wrench
• 5. 5 mm Allen wrench
• 6. 4 Screws

Diagram Description: The box contains the scooter's front and rear wheel compartments, tiller and handlebars, approved power adapter/charging unit, a 4mm Allen wrench, a 5mm Allen wrench, and 4 screws.

Remove all packing material, then inspect each item for any accidental damage that may have occurred during shipping.

Get To Know Your Scooter

The electric scooter comes partially assembled.

Diagram Description: The scooter features a kickstand, battery box, front button, back button, charger port, and hub motor.

Assemble Your Scooter

1. Assemble Front and Rear Wheel Compartments

Assemble the front wheel compartment and rear wheel compartment together. Take the 4 screws and use the 5mm Allen Wrench to tighten the screws. Once the screws are tightened, open the kickstand and straighten the scooter out.

2. Insert Tiller into the Head Tube with Wrench

Take the tiller component and insert the tiller into the head tube. Use the 4mm Allen wrench to tighten.

3. Remove Screw from Block on Top of the Tiller

Use the 4mm Allen wrench to remove the screws from the block on the top of the tiller. Put the handlebar on and cover with the top of the block. Tighten the screws. Test the scooter after you've finished assembling.

Charge Your Scooter

Before using the scooter, you must fully charge the battery.

Illustration Description: Illustration shows the electric scooter being charged via its power adapter connected to a wall outlet. The charging port is visible on the scooter.

Charging Instructions

1. Open the rubber charging port cover.
2. Insert the charging plug into the port.
3. The charger box will have a green light when fully charged and a red light when charging.
4. When you are done charging, be sure to cover the charging port to keep it clear of dust and debris.
5. Charging Time: 7 hours

Diagram Description: Diagrams illustrate opening the charging port cover and inserting the charging plug.

Scooter Console Functions

To power the scooter on, you must place your foot on the front button and kick to start.

To accelerate the scooter, place your first foot on the front button and kick to start. Once the scooter is moving, place your second foot on the back button to engage the electric motor to accelerate. (Caution: If you don't wish to accelerate any more while riding, remove your foot from the back button and the motor will turn off).

To brake, remove your back foot from the back button and place your foot on the rear fender brake to slow down or stop.

Diagram Description: A side view of the scooter is shown with labels for Kickstand, Battery Box, Front Button, Back Button, Charger port, and Hub motor.

Riding Tips

1. Start riding your scooter with one foot on the front button and one foot on the ground. Use your foot on the ground to push off.
2. Press the rear fender foot brake with your foot to slow down or stop.
3. The scooter performs best on a smooth surface, e.g., carparks, smooth roads, footpaths, & bike lanes.
4. Always clean your scooter (wheels, platform, etc.); it's a machine and needs maintenance.
5. Be aware of the terrain you are riding on; watch out for curbs and obstacles!

Maintenance & Repair

If you regularly clean and maintain your electric scooter, it will extend its life.

Cleaning and Storage

If the electric scooter surface is dirty, wipe it clean with a soft cloth.

DO NOT use alcohol, gasoline, kerosene, or other corrosive chemical solvents to clean the scooter. It can severely damage the appearance and structure of the scooter. Do not use a pressure washer, as it may also cause damage to the electronics.

Storage

When not using your scooter, store it in a dry and cool location. Avoid storing your scooter outdoors because sun exposure can damage its appearance and may cause wear on the battery and tires.

Battery Information

Only use the approved Gotrax power adapter to charge your scooter; others may cause a risk of fire, and equipment may be damaged.

Improper disposal of used batteries may seriously pollute the environment. Please comply with local disposal regulations.

Make sure to store your scooter and power adapter in conditions that do not exceed 122 degrees Fahrenheit or go below -4 degrees Fahrenheit.

Warning - Risk of Fire: No User Serviceable Parts. Prolonged exposure to UV Rays, Rain, and the Elements may damage the enclosed materials. Store indoors when not in use.

Troubleshooting

We frequently update our user manuals at gotrax.com and reserve the right to update and change manuals online.

Please contact the Gotrax customer service team if you are experiencing problems or need more detailed information. They can be reached at gotrax.com.

Warranty

For warranty information, please visit us at www.gotrax.com.

GOTRAX

WWW.GOTRAX.COM

#RIDEGOTRAX

[Twitter] [Instagram] [Facebook] [YouTube]

GOLABS, INC

GoTrax.com

2201 Luna Rd.

Carrollton, TX 75006