ARTEC SE-PEQ Parametric Equalizer
Professional Parametric Equalizer for all Instrument
Specifications
- Battery: 9V Alkaline 6LR61 or 6F22
- DC power supply: 9V Regulated
- Power consumption: 10mA
- Frequency response: 10Hz to 20kHz
- Input impedance: 1Mohm
- Output impedance: 1kohm
- Dimension: 75.5 x 115.5 x 47.5 (mm)
- Weight: 260g (include battery)
Battery & Power
If the indicator light blinks or does not light up while the effect is on, it signifies that the battery is nearly depleted and requires replacement. This also indicates that the power supply voltage is too low or disconnected when using a power adapter.
When using batteries, please use ALKALINE batteries to prevent leakage damage.
When using the pedal with an AC adaptor or DC power supply system, please use a DC9V REGULATED (100mA or higher) power supply. Using unregulated or switching power supplies, especially from IT systems, can cause high-frequency hum noise.
Limited Warranty
Products manufactured by ARTEC are warranted to be free from defects in workmanship and materials for a period of two years from the date of purchase. For warranty service, please contact the authorized dealer or shop in your region.
Packaging and Disposal
♻️ Packaging: Environmentally friendly materials have been selected for transport and protective packaging, suitable for normal recycling. Ensure that plastic bags and packaging are disposed of properly. Do not discard these materials with your normal household waste; ensure they are collected for recycling. Please follow the notes and markings on the packaging.
⚠️ Product Care: The plasticiser contained in the rubber feet of this product may react with the coating of your parquet, linoleum, laminate, or PVC floor, potentially causing permanent dark stains over time. In case of doubt, do not place the rubber feet directly on the floor; use felt-pad floor protectors or a carpet.
?️ Disposal: This product is subject to the European Waste Electrical and Electronic Equipment Directive (WEEE) in its current valid version. Do not dispose of this device with your normal household waste. Dispose of this product through an approved waste disposal firm or your local waste facility. Comply with the rules and regulations applicable in your country. If in doubt, consult your local waste disposal facility.
Device Diagram Description
The front panel of the ARTEC SE-PEQ Parametric Equalizer features controls and connections for shaping audio signals.
Controls:
- LEVEL Knob: Controls the output level of the effect.
- WIDTH Knob: Adjusts the bandwidth of the frequency filter, ranging from narrow to wide.
- GAIN Knob: Controls the amount of boost or cut for the selected frequency band, with a range of -10dB to +10dB.
- FREQ Knob: Selects the center frequency for the filter, adjustable from 30 Hz to 8000 Hz.
Connections:
- INPUT Jack: For connecting the instrument or audio source.
- OUTPUT Jack: For connecting to the amplifier or next device in the signal chain.
- DC9V Jack: For connecting a 9V DC power supply (center negative, 100mA or higher recommended).
Indicators and Switches:
- Indicator Light: Shows the status of the effect (e.g., on/off, battery level).
- Foot Switch: Engages or bypasses the effect (Direct Bypass).
The panel also displays the brand name "ARTEC", the model name "SE-PEQ", and descriptive text like "Parametric Equalizer", "Professional Parametric Equalizer for all Instrument", and "HANDCRAFTED ANALOG SYSTEM". The model identifier "2012-A-ENG" is also present.
