Bernstein Duschkabine DX407 Assembly Instructions

Product Information

Product Name: Duschkabine DX407

Also known as: Shower Enclosures DX407, Parois de Douche DX407, Box Doccia DX407

Assembly Manual Version: III / 2018

Required Tools

• Pencil ✏️
• Screwdriver ?
• Drill ?
• Measuring tape ?
• Scissors ✂️
• Spirit level ?
• Allen key (included) ?
• Silicone ?
• Rubber mallet ?

Important Notes

Arrows indicate the 'top' side. If no arrow is present, the part is usable on both sides.

Dimensions

Please observe the following measurements:

Scope of Delivery

The following parts are included in the delivery:

• Glass panels (x1, x1, x2)
• Shower tray (if ordered) (x1)
• Profiles (x2)
• Corner connectors (x2)
• Handle (x1)
• Hinges (x2)
• Support brackets (x1)
• Fixing elements (x1, x1, x2, x2)
• Screws (4x16 - x4, 4x16 - x2, 4x30 - x12)
• Sealing strip (x14)
• Spacer (4mm - x1)
• Drill bit (Ø3.2 - x1)

Important Notes:

• Do not overtighten screws connecting to glass using a power drill; tighten by hand only.
• As a guideline for positioning wall profiles when using a shower tray, the outer edge of the profile should be approximately 15mm from the outer edge of the shower tray, or follow the guideline for Dimension A as shown in the drawing.

Assembly Steps

1. Align the shower tray using the spirit level and connect the drain.
2. Align the profiles as shown in the illustration, use the spirit level, and mark the drill holes with a pencil.
3. Drill the holes and screw the profiles in place using appropriate wall plugs. Ensure you use wall plugs suitable for your walls.
4. Insert the small rubber buffers between the glass and the shower tray.
5. Slide the fixed glass elements into the aluminum profiles. Important: The inside of the glass elements is nano-coated, and the outside has a marking.
6. Screw the hinges onto the fixed glass elements.
7. Attach the glass doors via the hinges. Attach the magnetic and rubber strips to the glass elements as shown in the illustration.
8. Align the side parts and pre-drill the holes. Then screw in the aluminum rails and attach the rail covers.
9. Install the aluminum sealing strip using the plastic holders as shown. Apply silicone under the sealing strip.
10. Attach the supplied wall brackets as shown in the illustration.
11. Screw on the door handle.
12. Attach the sealing lips to the doors.
13. Place the covers on top of the aluminum rails.
14. Apply silicone seals as shown in the illustration along the aluminum profiles and the fixed glass elements.