ErGear Keyboard Tray

Contact Information

For support, please contact:

• 1-800-651-9525 (US/CA) Mon-Fri, 8am-8pm (CST)
• 44-808-196-3875 (UK) Mon-Fri, 2pm-10pm (UTC)
• Email: support@ergear.com
• Website: https://ergear.com

Important Safety Information

• Verify all parts are received and undamaged by checking package contents against the supplied parts and hardware list. Contact technical support or customer service for replacement parts.
• Read and follow all instructions carefully. ErGear is not liable for damage or injury from improper mounting, incorrect assembly, or inappropriate use.

Product Specifications

• Maximum weight capacity: 11 lbs (5kg)
• Fits desktop thickness: 0.39" – 1.18" (10-30mm)

Parts and Hardware

Supplied Parts:

• 01A x 1: Left Tray
• 01B x 1: Right Tray
• 02 x 2: Connector
• 03 x 1: Keyboard Stopper
• 04 x 1: Left C-Clamp
• 05 x 1: Right C-Clamp
• 06 x 2: Bracket
• 07 x 2: Washer
• 08 x 2: Keyboard Slide

Hardware:

• A x 8: M5 x 10mm Bolt
• B x 8: M5 x 10mm Bolt
• C x 4: M4 x 8mm Bolt
• D x 4: M8 x 20mm Bolt
• E x 4: Nut
• F x 4: Washer
• G x 4: Washer
• H x 1: Allen Key
• I x 1: Wrench

Tools Needed (Not Included)

• [Phillips Screwdriver]

Installation Instructions

Step 1: Attaching Trays to Desk

Attach the Left Tray (01A) and Right Tray (01B) to the underside of the desk using eight M5 x 10mm Bolts (A) and two Connectors (02). Ensure a tight fit with no gap. [Screwdriver icon used for tightening bolts].

Step 2: Attaching Slides and Stopper

Attach the Keyboard Slides (08) to the desk and the Keyboard Stopper (03) using eight M5 x 10mm Bolts (B). Tighten with a [Screwdriver].

Step 3: Attaching C-Clamps

Attach the C-Clamps (06) to the Keyboard Slides (08) using four M4 x 8mm Bolts (C) and four Washers (G). Tighten with an [Allen Key] (H).

Tip: Position the drawer slides toward the back for easier bracket installation.

Step 4A: Securing for Rectangular Desk

Attach the C-Clamps (04) to the desk using four M8 x 20mm Bolts (D), four Washers (F), and four Nuts (E). Then, attach the tray assembly to the C-Clamps using bolts (H). Use a [Screwdriver] and [Wrench] for tightening.

Step 4B: Securing for L-Shaped Desk

For L-shaped desks, follow a similar procedure as Step 4A. Fine-tune C-clamp positions to fit, remove the keyboard tray, then fully tighten the bolts. [Screwdriver icon used for tightening bolts].

Step 5: Tray Operation

Slide the tray in or out. The rubber detents will hold it open or closed when engaged. [Arrow icons indicating sliding motion used].