FEBUS Luminaire Installation Instructions

Safety Notes

• Never work when voltage is present on the luminaire.
• The installation must be performed by a professional installer in compliance with the standards and regulations relating to electrical installations.
• Risk of electrostatic discharges (ESD Norm). Handle with precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasives products to clean the fixture.
• Keep these instructions for dismantling or future maintenance.
• Additional information about RESISTEX luminaires can be found on the website: www.resistex-sa.com.
• RESISTEX cannot be responsible for any misuse of the product.

Installation Guide

The FEBUS luminaire is designed for professional installation. Please follow the steps outlined below.

Wiring Diagram

A diagram shows the connection of cables. Live (L) and Neutral (N) wires from the power source connect to a switch, then to the driver. The driver's positive (+) and negative (-) terminals connect to the DOWN LIGHT.

Mounting / Installation

The installation involves several steps, illustrated with diagrams:

1. Step 1: Shows a circular fixture with a 360° rotation indicator. Dimensions provided are Ø140 mm and Ø220 mm.
2. Step 2: Illustrates inserting the luminaire into a ceiling opening. A close-up shows the connection of L (Live), N (Neutral), and ground wires.
3. Step 3: Depicts the luminaire being fitted into the ceiling opening, with clips shown for securing it.
4. Step 4: Shows the fully installed luminaire in the ceiling, with heat dissipation fins visible.

Company Information

RESISTEX EXPLOITATION

11 Quai de la Banquière CS 80010, 06730 Saint-André-de-la-Roche, France

Tel: 04 93 276 276

Fax: 04 93 276 280

Email: contact@resistex-sa.com

APE: 2740Z

Siret: 487 593 477 00010

Capital: SAS CAPITAL 649979

VAT: F.R. 73 487 593 477