CMF Watch Pro 2 User Guide

Product Overview

The CMF Watch Pro 2 features a functional crown and a display screen on the front. The back of the watch includes a heart rate and blood oxygen monitoring sensor, a speaker, a microphone, and charging contacts.

Change Bezel

Remove the Bezel

1. Press your index finger and thumb on both sides of the bezel or press your palm against the entire bezel. Rotate it counterclockwise at an angle (about 20 degrees) with a little force until it can no longer rotate.
2. Pinch up vertically with two fingers to remove the bezel accessory.

Install Bezel

1. Pick up the bezel, align the marking point on the inside of the bezel with the marking point at 12 o'clock on the screen of the watch body. The CMF by Nothing logo should be placed at 7 o'clock on the screen of the watch body. Lower it horizontally and fasten it to the watch body.
2. Press your index finger and thumb on both sides of the bezel or press your palm against the entire bezel. Rotate it clockwise with a little force until there is an obvious snap/click into place.

Precautions

• When disassembling the bezel accessories counterclockwise, avoid applying too much force to prevent damage to the internal structure.
• When installing the bezel accessories clockwise, ensure that the bezel is horizontally snapped onto the watch body before rotating it to prevent damage to the internal structure.
• It is not recommended to wear the watch without the bezel accessories attached, as it may scratch the skin or wear down the internal structure.
• The identification mark on the back of the bezel must be aligned with the mark at the 12 o'clock position of the watch screen, and the CMF by Nothing logo should be placed at approximately 7 o'clock before tightening it by rotating clockwise.
• Frequent disassembly and assembly of the bezel accessories can cause wear and tear to the internal structure, leading to failure to tighten or loosen, which is a normal phenomenon. Please ensure a reasonable frequency of disassembling and assembling to extend the lifespan of bezel accessories.

Change Straps

To remove and replace a strap: Please turn the watch over and find the quick-release lever – there's one on each end and where the strap nests into the frame. Slide the quick-release lever and hold it to remove a strap from the watch or attach a strap to the watch.

Charge

Charging

To charge the watch, place the watch on the charging base. Make sure both metal pads on the back of the watch are aligned with the metal tips on the line.

Before charging, please wipe away sweat or moisture residue to keep the charging contacts of the watch clean.

Wearing Precautions

• For the best heart rate measurement results, wear the watch a 1-2 finger width distance from your wrist bone. Fasten it comfortably and not too tight.
• The watch and strap are made of materials that are safe to wear on skin. If you experience skin discomfort while wearing the watch, stop wearing it and consult a doctor or specialist.