MANUAL

TOOLS REQUIRED FOR DISASSEMBLY

• 1. Wire
• 2. Mounting bracket
• 3. Protocol box
• 4. Installation tools

Disassembly:

1. Use a pry bar to open the lift window switch button, pull out the connecting wire, and unscrew the screw.

   [Image: Pry bar opening window switch, wire being pulled, screw being unscrewed]

2. Pry open the decorative panel below the steering wheel, unscrew the screws fixing the upper frame on both sides of the steering wheel, then unscrew the screws securing the storage box above the radio, and remove the entire frame.

   [Image: Decorative panel removal, screws being unscrewed from steering wheel frame and storage box]

3. Remove the three air conditioning vents from the original vehicle frame, and take off the white clips.

   [Image: Air conditioning vents being removed, white clips being detached]

4. Use a screwdriver to unscrew the four screws on both sides of the radio, remove the radio, and unplug the connected wires.

   [Image: Screwdriver removing radio screws, radio being pulled out, wires being unplugged]

PROPOSE

Before starting the replacement job, you should ensure the car's power is cut off during the installation. Use a plastic pry tool and a screwdriver.

Installation:

(If the wiring harness does not match, please contact customer service to request the correct wiring harness)

1. Install the leftmost air conditioning vent onto the new vehicle frame, and then mount the frame above the steering wheel.

   [Image: Air conditioning vent installed on new frame, frame mounted above steering wheel]

2. Assemble the storage box and the new frame, tighten the fixed screws. Tighten the four screws on both sides of the radio, secure the radio onto the new frame, and attach the white clips.

   [Image: Storage box and frame assembled, screws tightened, radio secured, white clips attached]

3. Connect the wires between the original car and the radio, insert the protocol box, and install the radio in its designated position. Tighten the two screws above and below the radio.

   [Image: Wires connected, protocol box inserted, radio installed, screws tightened]

4. Tighten the two screws on both sides of the steering wheel securing the vehicle frame. Connect the wires between the lift window switch button and the original car, placing it back in its original position. Install the air conditioning vent, and secure the plastic panel below the steering wheel by fitting it upwards.

   [Image: Screws tightened on steering wheel frame, wires connected to window switch, panel fitted upwards]

GENTLE REMINDERS

Due to the complexity of the product structure, you may encounter some problems during installation. If you still have any questions about the installation after reading this manual, you can contact us and we will respond to you within 24 hours. We will do our best to solve the problem for you until you are satisfied.

After-sales email: cheyang728@gmail.com

WARN FCC WARNING

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.