Bounder LED Shop Light User Manual

Product Description

The Bounder LED Shop Light offers:

• 4400 Lumens
• D-Shaped Light Tube
• 6500K Daylight White illumination
• 5-Year Warranty
• 250W Equivalency
• 4 Lights Linkable capability

Bounder is committed to technological innovation and upholding its brand values of "Professionalism + Innovation."

Safety Information

! IMPORTANT: Read all safety precautions and installations carefully before installing this fixture.

Risk of Fire

1. Only 4 lights can be connected in series at a time. Connecting more than 4 lights may cause wire temperature to rise, potentially leading to fire.
2. Connection to external high-power devices is strictly prohibited as it may cause fire.
3. Keep flammable articles away from the lights.

Risk of Electric Shock

1. All electrical connections must comply with local and National Electric Code Standards.
2. Do not handle the electrified fixture with wet hands, especially when standing on a wet or damp surface or in water.
3. Turn off the switch and circuit breaker before installing the fixture.
4. Do not alter, relocate, or remove the wiring during installation.

Risk of Injury

1. Wear gloves and safety eyeglasses when installing the fixture or performing maintenance.
2. Avoid direct eye exposure to the light source while it is on.

Installation Tips

1. Assure that the fixture is mounted onto a structurally sound surface that will support the fixture.
2. The maximum distance to the receptacle is determined by the length of the cord provided.
3. The fixture is intended to be installed directly beneath a ceiling-mounted receptacle. Excess cord should be secured to one of the supporting chains with a cable tie to keep it out of the work space.

WARNING: Failure to comply with these instructions could result in potentially fatal electric shock and property damage.

Components

Each light contains the following parts. Check that there is no shortage before starting the installation:

• 2 x Hanging Chain with Hook
• 3 x Plastic Dry Wall Anchor
• 3 x Screw
• 3 x Ceiling Hook

Note: The unit is intended to be installed directly beneath a ceiling-mounted receptacle. If there is excess cord, bind with string or a cable tie to keep it out of work space.

Installation

Ceiling Installation

Required Accessories

2 x Screw / 2 x Ceiling Hook / 2 x Plastic Dry Wall Anchor

1. Install fixture flushmount using screws. Install two screws on the mounting surface, with spacing between screws as follows: 45" (for 4ft lamp), 33" (for 3ft lamp), 21" (for 2ft lamp). (See Figure 1) The gap (D) should be 0.05".
2. Lift the fixture up to the screws and slide to one side to secure it into place. The fixture should be firmly fixed against the screws. (See Figure 2)
3. Plug the power cord into the outlet.

Suspending Installation

Required Accessories

2 x Hanging Chain with Hook / 2 x Ceiling Hook / 2 x Plastic Dry Wall Anchor

Attach the ceiling hooks

1. Choose the desired location for the light fixture, ensuring it is within reach of an outlet. Use a pencil to mark the ceiling where each ceiling hook should be placed. Screw the hooks into place until secure. (See Figure 3)
2. Hook the hanging chain with the lamp. (See Figure 4)
3. Hook the hanging chain with the ceiling hook. (See Figure 5)
4. Plug the power cord into the outlet.

Installation Precautions

1. If multiple lights are to be installed, ensure the distance from the end of one light to the head of the next is less than the 5' power supply cord length.
2. Plug the power cord into the receptacle from the front light to the next one. (See Figure 6)
3. Plug the power cord into an outlet and use the pull chain to power each light on. (See Figure 6)

NOTE: To preclude the risk of fire: only 4 lights can be connected in series at a time, and connection to external high-power devices is strictly prohibited.