Quick Start Guide

1. ADD HE DETERGENT

Follow manufacturer's instructions to determine amount of laundry products to use.

2. LOAD THE WASHER

Ensure items are loaded loosely and do not overload the washer.

3. ADD BLEACH if desired.

Add bleach to the designated bleach dispenser if using.

4. ADD FABRIC SOFTENER if desired.

Fabric softener will automatically be added during the final rinse.

To add fabric softener manually, lift the lid during the final rinse, add the recommended amount of liquid fabric softener, and close the lid.

(Illustration shows adding softener with and without a dispenser)

5. SELECT CYCLE

Choose the appropriate cycle for your load:

• DELICATES
• MIXED
• NORMAL
• POWERWASH
• BULKY / TOWELS
• RINSE & SPIN
• DRAIN & SPIN

(Illustration shows a dial with cycle selections)

6. SELECT WASH TEMP

Select the desired water temperature:

• COLD
• TAP COLD
• WARM
• HOT

(Illustration shows a temperature dial)

7. SELECT OPTIONS

Choose additional options as needed:

• OFF
• PRESOAK
• EXTRA RINSE
• PRESOAK & EXTRA RINSE

(Illustration shows an options dial)

8. PRESS START/PAUSE

Press and release the START/PAUSE button to begin the cycle.

To Cancel: Hold the START/PAUSE button for 3 seconds. The cycle will cancel and the washer will drain.

Note: If you press Start/Pause to pause a cycle, you must press Start/Pause again to resume the cycle.

(Illustration shows the START/PAUSE button and status indicators: STATUS, FILL, SOAK/WASH, RINSE, FINAL SPIN, DONE, LID LOCKED)

9. ADD A GARMENT

During the Fill and Soak/Wash phases, you may open the lid to add a garment. Close the lid promptly.

IMPORTANT: If the lid is left open for more than 10 minutes, the wash cycle will cancel and the water will pump out.