Installation Guide for westomatic models including: SHMOO Vending Service, SHMOO, SHMOO Vending, Vending Service, Vending
Shmoo Service Page – WeSupport
INSTALLATION GUIDE Welcome TO YOUR NEW SHMOO WE KNOW YOU'RE EXCITED SO LETS GET GOING! INITIAL CHECK LIST CHECK FOR DAMAGE Report any issues LEVEL UP Using the adjustable feet and a spirit level make sure the machine is level. CONNECT WATER Connect mains water to the back of the machine ATTACH PLINTHS Detachable for easy maneuvering / move into position INSTALL WATER FILTER(S) (if not already installed) TURN WATER SHUT OFF VALVE ON FLUSH WATER FILTERS Flush buttons located on inside of door AND YOU'RE READY TO FILL THE MACHINE SCAN QR CODE FOR HELP ON/OFF SWITCH and fuses INFO PACK UV FILTER WATER SHUT OFF WATER FILTERS PLINTHS WASTE BUCKET FLUSH SWITCH ON/OFF CANISTERS CHUTES MIXING BOWLS & CAPS SANITATION HOOK NOZZLES FILLING GUIDE 1.TWIST CHUTE UPWARDS 2.LIFT UP & REMOVE CANISTER FROM FLAVOUR DECK 3.HOOK CANISTER INTO FILLING CLIPS 4.USE FUNNEL PROVIDED TO HELP FILL 5.REPLACE CANISTER TO FLAVOUR DECK 6.TWIST CHUTE INTO PLACE - POINT STRAIGHT DOWN 7.ENSURE MIXING BOWL IS CLEAN AND CLEAR OF POWDER 8.PRESS FLUSH TO RUN A RINSE CYCLE HYGIENE KIT FILLING FUNNEL PLINTHS CANNISTER CLIP TOP FIRST WASTE BUCKET User Guide 4 SIMPLE STEPS PLACE BOTTLE IN DISPENSE AREA HOVER FINGER OVER BUTTON TO SELECT A DRINK ALLOW MACHINE TO DISPENSE DRINK REMOVE BOTTLE FROM MACHINE AND ENJOY CONTACT Units 7-8 Block 4 Forde Court, Forde Road, Brunel Industrial Estate, Newton Abbot, Devon, TQ12 4BT www.westomatic.com TROUBLESHOOTING GUIDE MACHINE ISN'T DETECTING BOTTLE - Clean the sensor in dispense area. - If the issue persists, sensor may need adjusting by engineer. WASTE BUCKET FULL - Remove waste bucket and empty. - Ensure weighted pipe is placed back in the bucket. ERROR CODE 14 - Button Failure. - Call-out required by engineer. POWDER NOT DISPENSING - Check there is still powder in canisters (agitate to free powder) . - Clean dispense nozzle/whipper/pipe to ensure there is no blockage. - Press flush buttons to flush pipes. CHILLER NOT DISPENSING COLD WATER - Check Fuses - If issue persists contact engineer SOUND AND VIDEO ADJUSTMENTS - Scan QR for instructions on using the screen PART NUMBER: 1011013 +44 (0)1626 323100 support@westomatic.com www.westomatic.comCanva Canva