Rubicson Wireless Thermometer
Art nr: 48044
Installation
The battery compartment is at the back of the thermometer. Remove the lid and insert the batteries. Put the lid back on. Repeat the process on the remote sensor. Both units have stands if you want to place them on a stable surface. You can also hang them up.
Time settings
- Press and hold the SET/SNZ button for two seconds. A number flashes, followed by an “H”.
- Choose whether to display 12 or 24 hour clock with UP and DOWN. Confirm every step with SET/SNZ.
- Enter the correct hour.
- Enter the correct minute.
- Enter the correct year.
- Enter the correct month.
- Enter the correct day.
- Choose whether to display Celsius (°C) or Fahrenheit (°F).
- Confirm one final time with SET/SNZ.
Receiver
The included sensor is set to match the thermometer per default. You can change the transmitting channel on the sensor by opening the battery hatch and pressing the CH button to swap between channels 1 to 3. You can also choose whether to display Celsius (°C) or Fahrenheit (°F) by pressing the °C/°F button. Press the DOWN button on the thermometer to change the current channel. If you want to delete the current channel data press and hold the DOWN button for 2 seconds. The thermometer will start searching for sensors to connect with. You can spread out 3 sensors, pair them up and then be able to monitor their temperatures individually.
Temperature memory
Press the UP button to see the highest measured temperatures inside and outside. The display shows MAX. Press the UP button again to see the lowest measured temperatures inside and outside. The display shows MIN. To delete the temperature data, press and hold the UP button for two seconds. Press UP again to return to default mode. The memory is automatically cleared every night at 0:00.
Alarm
Press SET/SNZ once to enter the alarm mode followed by pressing and holding the SET/SNZ button for 2 seconds to be able to set the alarm time. Confirm hour and minutes. Once set, enter alarm mode again and press the UP button once. You'll see a small bell ? on the display indicating the alarm is activated. When the alarm goes off press the SET/SNZ button once to snooze 5 minutes and UP to turn it off. Press UP again to reactivate it.
Specifications
| Temperature range inside | 0-50 °C |
| Temperature range outside | -20-50 °C |
| Clock | 12/24 h |
| Unit | °C/°F |
| Dimensions | 115 x 70 x 22 mm (main unit) 95 x 60 x 30 mm (sensor) |
| Batteries | 4x AAA (not incl.) |
Safety information
Exhausted batteries are to be removed and replaced by a correct type battery. Dispose of used batteries according to the instructions.
