6-Outlet Mechanical Timer Yard Stake

Features

• 24-hour push-pin mechanical timer
• 6 outlets

Setup

1. Set "ON" Time

   Locate the gray pins and push them DOWN at the marked times when the attached device is to be "ON". Each pin represents a 30-minute time interval.

2. Set "CURRENT TIME"

   Rotate the entire gray push-pin dial clockwise until the arrow marked "CURRENT TIME" aligns with the current time of day on the dial. "AM" hours are highlighted in WHITE. "PM" hours are highlighted in BLACK.

3. Plug into Electrical Outlet

   Use up to 6 devices with the YARD STAKE. Plug the device into the outlet on the side of the YARD STAKE.

Helpful Tips

• This timer YARD STAKE repeats the same settings daily.
• To push down or pull up the gray pins, use your finger or the tip of a small non-metallic insulated tool, such as a pencil or toothpick.
• Set up to 48 different "ON" and "OFF" times in a 24-hour period by the positioning of the gray pins. Pins pressed down represent the 'ON' time. Pins in the up position represent 'OFF' time.
• Once the YARD STAKE is set on the ground, it will sit at a slight upward angle, making it easier to read and program the unit.

In Case of Power Failure

The timer will stop operating if the power goes out. Once power is restored, reset the time of day as explained in Step 2 of the instructions.

Safety Information & Specifications

• This YARD STAKE is for use with a 125 VAC power source.
• 125VAC / 60Hz

Do Not Attach a Device That Exceeds the Unit Ratings:

• 15A / 1875W Resistive (General Purpose)
• 8A / 1000W Tungsten (Incandescent)
• 1/2 HP (Horsepower Motor)

Warning: Risk of Electric Shock

• Keep children away.
• Unplug timer before cleaning.
• Fully insert plug.
• Do not use near standing water.

Risk of Fire

• Do not use to control appliances that contain heating elements (cooking appliances, heaters, irons, etc.).
• Do not exceed electrical ratings.